Tach Learning; Remote Start Diagnostics - Clarion SR5000 Installation Manual

Tach Learning

T T o o l l e e a a r r n n t t h h e e t t a a c c h h s s i i g g n n a a l l : :
1.
2.
3.
4.
NOTE: A dim or pulsing LED when learning tach means the unit has not learned the tach signal.
Test all connections, and if good, relocate the tach input wire and continue with tach learning
procedure.

Remote Start Diagnostics

The unit has the ability to report the cause of the last shutdown of the remote start system.
T T o o e e n n t t e e r r d d i i a a g g n n o o s s t t i i c c m m o o d d e e : :
1.
2.
3.
34
Start the vehicle with the key.
Within 5 seconds, press and hold the override switch.
The LED will light constant when the tach signal is learned.
Release the override switch.
Turn the ignition off.
Press and hold the override switch.
Turn the ignition on then off again.