Advertisement
The Valet/Program switch, plugged into the blue port, is used for programming. There is a basic sequence of
steps to remember whenever programming this unit: Door, Key, Choose, Transmit and Release.
1.
O O p p e e n n a a d d o o o o r r . . (The GREEN wire, H1/5, or the VIOLET, H1/7 must be connected.)
2.
K K e e y y . . Turn the ignition to the ON position.
3.
C C h h o o o o s s e e . . Within 10 seconds, press and release the Program switch the number of times cor-
responding to the desired channel listed below. Once you have selected the channel, press
the switch once more and H H O O L L D D it. The LED will flash and the horn will honk (if con-
nected) to confirm the selected channel. Do not release the Program switch.
C C H H A A N N N N E E L L N N U U M M B B E E R R
1
2
3
4
5
6
7
8
9
10
11
12
* * N N O O T T E E : : For Auto Learn Configurations, see Transmitter Configurations section of this
guide.
4.
T T r r a a n n s s m m i i t t . . While H H O O L L D D I I N N G G the Valet/Program switch, press the button on the transmitter
that you would like to control the selected receiver channel. The unit will chirp to confirm
that the code has been successfully programmed. It is not possible to teach a transmit-
ter button to the system more than once.
5.
R R e e l l e e a a s s e e . . Once the code is learned, the Valet/Program switch can be released.
You can advance from programming one channel to another by releasing the Valet/Program switch and tapping
it to advance channels and then H H O O L L D D I I N N G G it. For instance: You have programmed Channel 1 and you want to
F F U U N N C C T T I I O O N N
Auto Learn Standard Configuration* * (default)
Arm only
Disarm only
Silent Mode™/Remote Valet®/Trunk Release
No function
Channel 4
Channel 5
No function
No function
Arm/Disarm/Panic
Panic only
Delete all transmitters
W W I I R R E E C C O O L L O O R R
RED/WHITE
VIOLET/BLACK
WHITE/BLACK
2 2 5 5
Advertisement
