Advertisement
H H 1 1 / / 1 1 1 1 R R E E D D ( ( + + ) ) 1 1 2 2 V V c c o o n n s s t t a a n n t t p p o o w w e e r r i i n n p p u u t t
Before connecting this wire, remove the supplied fuse. Connect to the battery positive terminal or the constant
12V supply to the ignition switch.
N N O O T T E E : : Always use a fuse within 12 inches of the point you obtain (+)12V. Do not use the 15A
fuse in the harness for this purpose. This fuse protects the module itself.
H H 1 1 / / 1 1 2 2 R R E E D D / / W W H H I I T T E E c c h h a a n n n n e e l l 2 2 , , 2 2 0 0 0 0 m m A A ( ( - - ) ) o o u u t t p p u u t t
When the system receives the code controlling Channel 2, for longer than 1.5 seconds, the red/white wire will
supply an output as long as the transmission continues. This is often used to operate a trunk/hatch release or
other relay-driven function.
I I M M P P O O R R T T A A N N T T ! ! Never use this wire to drive anything but a relay or a low-current input! The tran-
sistorized output can only supply 200 mA of current. Connecting directly to a solenoid, motor,
or other high-current device will cause it to fail.
1 1 9 9
Advertisement
