Installation Of The Wall Bracket - Silvercrest SAS 7.4 LI C2 Operating Instructions Manual

■ If the handheld vacuum cleaner is deep-discharged, the charge indicator
lamp
switch off the appliance and start charging.

Installation of the wall bracket

DANGER! ELECTRIC SHOCK!
► Ensure that there are no power cables or other conduits or pipes in the wall
at the location where you intend to bore the holes for the wall bracket
Drilling into a current-carrying electric cable can be potentially fatal!
1) Place the barrel plug
shown in the following diagram:
–
Open up the small cover.
–
First, feed the cable through the cable routing and then push the barrel
plug
–
Then close the small cover again.
2) Select a suitable installation location for the wall bracket
It must be possible to remove the handheld vacuum cleaner easily and there
must be an accessible mains power socket for the mains adapter
3) Drill two holes about 34 mm apart. Use the wall bracket
holes, to ensure the correct spacing. The drill holes must be suitable for 6 mm
wall plugs.
4) Push the wall plugs into the holes and then screw the wall bracket
into place using the screws.
5) Connect the mains adapter
■ 54 │ GB │ MT
7
flashes alternately red and green (approx. 1 minute). In this case,
5
of the mains adapter
5
into the opening in the wall bracket
4
3
4
to a mains power socket.
3
3
into the wall bracket
so that it is firmly in place.
3
:
4
.
3
to mark the
3
firmly
SAS 7.4 LI C2
.
as