Ops-Core FORCE-ON-FORCE MANDIBLE Operator's Manual

Table of Contents

Download this manual

OPERATION

The Force-on-Force Mandible uses a soft, flexible

protective fabric with foam inserts that conform to

your weapon stock to enable sighting while in use.

Slide the Step-In Visor attachment

clip into the rail tracks on the

mandible arms.

Attach the Step-In Visor to the

attachment clips.

1. Spot-clean rigid components with a mild detergent and water.

2. Visually check the components for signs of breakage.

3. Clean dust and dirt by using air pressure.

NOTE: IF ANY DEFECTS ARE FOUND, THE DAMAGED COMPONENTS SHOULD BE REPLACED BEFORE USE.

FORCE-ON-FORCE

MANDIBLE

OPERATOR'S MANUAL

Helmet not included

For helmets equipped with Ops-Core

This product is covered by one or more patents.

For more information visit www.gentexcorp.com/patents

UM-1053 REV-A

ARC Rails

Table of Contents

Do you have a question about the FORCE-ON-FORCE MANDIBLE and is the answer not in the manual?

Page 1 NOTE: IF ANY DEFECTS ARE FOUND, THE DAMAGED COMPONENTS SHOULD BE REPLACED BEFORE USE. This product is covered by one or more patents. For more information visit www.gentexcorp.com/patents UM-1053 REV-A © 2019 Gentex Corporation. Ops-Core is a registered trademark of Gentex Corporation or its affiliates.
Page 2 ABOUT YOUR FORCE-ON-FORCE MANDIBLE DETACH SIDE PANELS The Ops-Core Force-on-Force Mandible is a lightweight, one size fits all accessory that offers protection from training munitions as well as blunt impact protection. The mandible is Compatible with any helmet equipped Detach the side panels from the mandible arms.