Ops-Core MOTO VISOR Operator's Manual

For sentry helmets

Enlarged version

INSTALLATION PROCEDURE

FASTEN CAM-LOC HANDLES

Fasten both the left and right Cam-Loc Handles to

secure the Moto Visor in place.

CLEANING & CARE

• Spot-clean the Moto Visor with a mild detergent and water.

• Visually check the entire Moto Visor for signs of breakage.

• Clean dust and dirt by using air pressure.

Check that the Cam-Loc Handles work properly.

NOTE: IF ANY DEFECTS ARE FOUND, THE DAMAGED COMPONENTS SHOULD BE REPLACED BEFORE USE.

MOTO VISOR

OPERATOR'S MANUAL

FOR SENTRY HELMETS

Table of Contents

Do you have a question about the MOTO VISOR and is the answer not in the manual?

Page 1 Moto Visor in place. OPERATOR’S MANUAL CLEANING & CARE • Spot-clean the Moto Visor with a mild detergent and water. • Visually check the entire Moto Visor for signs of breakage. • Clean dust and dirt by using air pressure.
Page 2 INTRODUCTION INSTALLATION PROCEDURE ABOUT YOUR VISOR: The Moto Visor quickly attaches to the Sentry Helmet without the use of tools. This manual covers the installation and basic operating RELOCATE NVG BUNGEES instructions for the Ops-Core Moto Visor. The Ops-Core Before the Sentry Visor can be properly installed,...