Prevue Pet Products 1307 Read First

Travel Carrier
Model: # 1307
Instructions online at www.prevuepet.com
1
To assemble the CAGE BODY,
you will need these pieces:
2
To add the ROOF and PERCH/
HANDLE, you will need these
pieces:
1307 — 04 /17 — USL
Set the roof into place. Posts at the corners of the roof will insert
into the holes at the top corners of the front and back panels.
Made in China for Prevue Pet Products, Inc., 224 N Maplewood Ave, Chicago IL 60612 USA • www.prevuepet.com • 1 [312] 243-3624 • customerservice @ prevuepet.com
read first
REVIEW BEFORE ASSEMBLY
• No tools are required for assembly
For assistance or replacement parts,
please contact Prevue Pet Products:
Touch the vertical frame rail surfaces together, aligning the knob on
the side panel with the hole on the back panel (fig.1.1) and the tab
extension on the side panel over the sleeve on the back panel (fig.1.2).
Slide the side panel down. The knob should lock into the hole
and the tab should slide into the sleeve.
Add on the side panel (with cup doors) and the front panel following
the same procedure.
fig.1.1
fig.1.2
312.243.3624
PHONE
www.prevuepet.com
ONLINE
EMAIL customerservice@prevuepet.com
Set the perch/handle unit into place, aligning the holes of the
bottom tabs with the holes on the front and back panels.
Screw the knobs into the aligned holes. This will secure the
handle to the carrier and lock the roof in place.