Overview; Parallel Interface Communication Modes - Citizen iDP-3221 Series User Manual

APPENDIX 2.
1.

Overview

The interface of the printer is a Level-1 compatible device according to IEEE-P1284. It supports the communication
modes described in 1.1 below.

1.1. Parallel Interface Communication Modes

The parallel interface of the printer provides three communication modes as outlined below.
turned on or reset, it defaults to Compatibility mode.
• Compatibility Mode
Data is transmitted from the host to the printer in units of one byte. Usually, this mode is used for data
transmission. You may switch to the other modes from Compatibility mode.
• Nibble Mode
Data is transmitted from the printer to the host in units of four bits. The data transmission from the printer uses
a status signal line. To send one byte of data in this mode, two sets of four-bit data are sent consecutively.
• Byte Mode
Data is transmitted from the printer to the host in units of one byte. Data transmission from the printer uses an
8-bit data signal line. For Byte mode, the host must be capable of toggling the signal direction over the 8-bit
data signal line. Communication from the host to the printer is called Forward mode, while communication
from the printer to the host is called Reverse mode.
BI-DIRECTIONAL PARALLEL INTERFACE
128
iDP3221 User's Manual
When the printer is
CITIZEN