Table of Contents
Advertisement
#11 CONDITION: Strap weld time is erratic.
CAUSE
Dirty or very dry valve in air motor valve housing.
#12 CONDITION: Weld time is too long.
CAUSE
Too much oil in the air supply system of the tool.
#13 CONDITION: The cut-off has become difficult.
CAUSE
1.
Strap residue jamming cutter mechanism.
2.
Adjust cutter as needed.
3.
Cutter blade worn or damaged beyond
adjustability.
4.
Broken or damaged cutter spring.
#14 CONDITION: Welded strap is misaligned.
CAUSE
The tool is not being operated properly.
REMEDY
Add a several drops of airline oil into the air inlet of the
tool and cycle several times to lubricate. If the
problem persists, review the air motor valve housing
maintenance instructions found in this manual.
REMEDY
Purge the tool of all excess oil. See instructions Excess
Oil Removal found in this manual.
REMEDY
1.
Clean parts as required.
2.
Adjust cutter per instructions in this manual as
required.
3.
Follow cutter blade replacement procedures.
4.
Replace as required.
REMEDY
Review "Tool Operation" on pages 10 & 11 of this
manual for proper operation of tool.
29
Advertisement
Table of Contents
