Signode TENSION-WELD VXT2-19 Operation, Parts And Safety Manual page 13

VXT2 STRAP SIZE CONVERSION
To convert (re-configure) a VXT2-16 to a
VXT2-19 or vice versa, two operations must
be performed.
1. The two inner guides (Key 103) must be
re-positioned (rotated) by loosening the
mounting screw (Key 104) and rotating
the guide 1/2 turn. The strap should then
appropriately contact the guide edge
marked "16" or "19".
2. The guide spacer (key 105) must also be
repositioned for the appropriate strap
size. Squeeze the tensioner foot lever to
expose the SHCS (Key 104) on the
tensioner foot. Temporarily remove this
screw. Remove the guide spacer (Key
105) from the tool. Reposition the guide
spacer between the feedwheel and the
guide plate for 19mm usage. Position the
guide spacer between the guide plate
and the weld housing for 16mm usage.
* Guide plate (Key 96) can not be removed
from tool. It is shown as is for clarity
only.
13