Advertisement
Application
Let the demolition hammer run at a low speed for the first 2–3 min after starting it in order to
allow the machine to warm up.
Start using the device once the temperature is high enough (according to the required impact
energy) in order to achieve an ideal starting position and thereby reduce the strain placed on
the device and its parts.
Notes:
When using the demolition hammer for the very first time, it should only be used at lower
speeds for the first 24 hours in order to extend its service life.
In order to achieve the best work results, it should be sufficient to operate the demolition ham -
mer at medium speed.
Stopping
Let go of the acceleration switch and let the machine run in idle state for about 1–2 min.
Then halt the motor by pressing the red stop switch (see Figure 6).
Maintenance
Air filter
Regularly check the air filter. Accumulations of dust and dirt may block it and as a result reduce the ca-
pacities of the motor and damage the cylinder. In case of the filter being dirty, remove it and carefully
clean it with mild detergent and lukewarm water. Make sure that the air filter has dried completely be -
fore it is reinserted. If the air filter should show signs of wear or damage, repair it or replace it with a
new one. If working in especially dusty environments, the maintenance cycle has to be adjusted ac-
cordingly.
Oil filter
A clogged oil filter reduces the demolition hammer's working speed as well as its power of impact and
does thereby not only affect its performance, but also increases the risk of the machine being dam-
aged and its operator being injured.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 62296
Page 8
03
2021-1
Advertisement
