Table of Contents
Advertisement
Quick Links
Operation Manual
Jackhammer
Item number 62296
Illustration similar, may vary depending on model
Read and follow the operating instructions and safety information before using for the first time.
Technical changes reserved!
Due to further developments, illustrations, functioning steps and technical data can differ
insignificantly.
Updating the documentation
If you have suggestions for improvement or have found any irregularities, please contact us.
Advertisement
Table of Contents
Related Manuals for WilTec JH95A
Summary of Contents for WilTec JH95A
- Page 1 Operation Manual Jackhammer Item number 62296 Illustration similar, may vary depending on model Read and follow the operating instructions and safety information before using for the first time. Technical changes reserved! Due to further developments, illustrations, functioning steps and technical data can differ insignificantly.
- Page 2 The information contained in this document is subject to change without prior notice. No part of this document can be copied or duplicated in another form without the prior written consent of WilTec Wildanger Technik GmbH. The WilTec Wildanger Technik GmbH assumes no liability for any errors in this user manual or the connection diagram.
-
Page 3: Main Components
Children are not allowed to use the device and should be supervised at all times in order to ensure that they do not play with it. © by WilTec Wildanger Technik GmbH Seite 3 http://www.WilTec.de... - Page 4 Avoid rapid acceleration as well as abrupt deceleration as the strain of these drastic changes • in working speed might damage the device. © by WilTec Wildanger Technik GmbH Seite 4 http://www.WilTec.de http://www.aoyue.eu October 2019 Version 2...
- Page 5 3. Do not overfill the tank and do not leave any fuel residue in the outlet. In case of fuel being spilled, remove it appropriately or wait for it to evaporate before starting the engine. 4. Always make sure to properly close the fuel tank cap properly after fuelling/refuelling. © by WilTec Wildanger Technik GmbH Seite 5 http://www.WilTec.de http://www.aoyue.eu...
- Page 6 50 cm. Do not let the recoil start rebound freely and instead guide it back in order to protect the starter. 3. Open the ventilation once the motor has been started. © by WilTec Wildanger Technik GmbH Seite 6 http://www.WilTec.de http://www.aoyue.eu...
-
Page 7: Stopping The Machine
A clogged oil filter reduces the jackhammer's working speed as well as its power of impact and does thereby not only affect its performance, but also increases the risk of the machine being damaged and its operator being injured. © by WilTec Wildanger Technik GmbH Seite 7 http://www.WilTec.de http://www.aoyue.eu... - Page 8 0.5 and 0.7 mm. If the spark plug is dirty, carefully remove accumulations of dirt with a wire brush. (Figure 10) © by WilTec Wildanger Technik GmbH Seite 8 http://www.WilTec.de http://www.aoyue.eu October 2019 Version 2...
-
Page 9: Troubleshooting
The device works fine, but the quality of the demolition is not sufficient Issue Solution The chisel is worn out Resharpen and reforge or replace the chisel © by WilTec Wildanger Technik GmbH Seite 9 http://www.WilTec.de http://www.aoyue.eu October 2019 Version 2... -
Page 10: Technical Specifications
2.5 N.m / 5000 r/min Impact frequency 700~1350 impacts per minute Power of impact 20~55 J Carburettor type H119-6A-00-210 Spark plug type BM6A Starting system Recoil start © by WilTec Wildanger Technik GmbH Seite 10 http://www.WilTec.de http://www.aoyue.eu October 2019 Version 2 http://www.teichtip.de... - Page 11 © by WilTec Wildanger Technik GmbH Seite 11 http://www.WilTec.de http://www.aoyue.eu October 2019 Version 2 http://www.teichtip.de...
-
Page 12: Parts List
Gasket Screw M5x15 Piston Screw M6x60 Circlip Muffler Piston pin Gasket Bearing washer Ignition coil Crank shaft Connection cable Needle roller bearing Motor base plate © by WilTec Wildanger Technik GmbH Seite 12 http://www.WilTec.de http://www.aoyue.eu October 2019 Version 2 http://www.teichtip.de... - Page 13 Gasket Bearing plate Gearbox Screw M5x10 Flat gasket Gear wheel Connecting rod Bearing 6202 Piston Bearing cover Damping ring Bearing 6205 O-ring Crankshaft Cylinder liner © by WilTec Wildanger Technik GmbH Seite 13 http://www.WilTec.de http://www.aoyue.eu October 2019 Version 2 http://www.teichtip.de...
- Page 14 Lock sleeve 116 Sleeve Straight pin 4x18 117 Rubber cuff Gearbox gasket 118 O-ring Gearbox cover 119 Damping ring Screw M6x16 120 Cylinder head gasket © by WilTec Wildanger Technik GmbH Seite 14 http://www.WilTec.de http://www.aoyue.eu October 2019 Version 2 http://www.teichtip.de...
- Page 15 © by WilTec Wildanger Technik GmbH Seite 15 http://www.WilTec.de http://www.aoyue.eu October 2019 Version 2 http://www.teichtip.de...
- Page 16 © by WilTec Wildanger Technik GmbH Seite 16 http://www.WilTec.de http://www.aoyue.eu October 2019 Version 2 http://www.teichtip.de...
-
Page 17: Disposal Regulations
All WilTec electric devices that fall under the WEEE regulations are labelled with the crossed-out wheeled waste bin logo. This logo indicates that this electric equipment must not be disposed with the domestic waste.