Advertisement
Safety precautions
This product is a petrol-driven demolition hammer, designed for compaction work and is therefore not
suited for the removal of larger rocks. Please make sure to carefully read the information and safety in-
structions found within this instruction manual and adhere to them in order to ensure an ideal mode of
operation while at the same time minimising the risk of accidents. The instructions found in this manual
thereby do not replace rules and regulations applying at your workplace, but complement them. Keep
this manual and make sure that it is in reach when working with this product.
This product must not be used by persons with limited physical, sensory or mental capabilities
or lack of experience and/or knowledge, unless they are instructed and supervised by a per-
son who is responsible for them and who is familiar with the product. Children must always be
kept away from the device and must not operate it under any circumstances.
When using the demolition hammer, always wear non-slip safety shoes, protective goggles,
hearing protection and appropriate work clothing. In addition, a dust mask and a hard hat
should be worn if the demolition hammer is to be used for a longer period of time.
When working with the demolition hammer, always ensure that you have a firm, secure footing
and only use the machine with both hands.
Do not smoke while operating the machine and do not use the machine when you are tired or
under the influence of alcohol, drugs or medication.
Start at a slow speed and increase the speed steadily.
Keep bystanders away from your work area as the use of the demolition hammer can cause
splintered pieces, gravel or rubble to be thrown up.
A medium speed setting between 3 and 4 is recommended and produces the best work res-
ults.
Do not exert any pressure on the machine during use and instead try to use the own weight of
the machine. For a high effect, a simple operation and to achieve optimal results, it does not
require too much effort.
Keep the handles clean, dry and free from oil or petrol residues.
Always switch off the engine when finishing or interrupting the work process.
Please check all fastening screws before each use. If they are loose, tighten the screws be-
fore use.
The use of pure gasoline (without two-stroke engine oil) as fuel is prohibited. It is imperative
that you adhere to the mixing ratio of fuel and lubricant prescribed in these operating instruc-
tions.
Petrol is extremely flammable, so only fill up in a sufficiently ventilated area and away from
sources of ignition. To do this, switch off the engine before filling up with fuel and let the
device cool down for a few minutes. When adding fuel, be careful not to add too much fuel. Do
not leave the fuel tank near the machine. If the fuel overflows, wait until it has evaporated,
then you can start the machine again.
Make sure to close the tank cap firmly and properly after filling it with fuel. Also check the tank
and the lid regularly for damage or signs of wear and tear and repair any defects before using
the device again.
Store fuel reserves only in areas where there are no substances that could start or generate
fires, explosions, or flying sparks.
If you use the demolition hammer in closed work areas, e. g. in tunnels and trenches, make
sure that there is enough fresh air, or use a fan or hood, as the exhaust gases contain danger-
ous carbon monoxide.
Avoid too quick acceleration or sudden braking, as this can damage the machine.
Avoid hitting the machine with chipped pieces when working at high speed or when removing
material.
If you want to transport the device over a longer distance, make sure that the tank has been
emptied beforehand.
To avoid damaging the individual parts, do not dismantle the demolition hammer, as this can
impair the lifespan of the demolition hammer and lead to an increased risk of accidents.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Item 62296
Page 4
03
2021-1
Advertisement
