Barometric Pressure Reading Precautions; Temperature Measurement; Checking The Current Temperature - Casio 5678 Operation Manual

Note
If you do not perform any operation for
●
about two minutes after pulling out the
crown, crown operations will
automatically become disabled. If that
happens, push the crown back in and
then pull it out again.
Barometric Pressure
Reading Precautions
The barometric pressure graph produced
●
by this watch can be used to obtain an idea
of upcoming weather conditions. However,
this watch should not be used in place of
precision instruments required for official
weather prediction and reporting.
Pressure sensor readings can be affected
●
by sudden changes in temperature.
Because of this, there may be some error in
the readings produced by the watch.
Watch Operation Guide 5678
The watch can be used to take current air
temperature readings.
Important!
Check the information at the link below
●
to find out how to ensure correct
readings.
Temperature Reading
l
Precautions
Temperature
Measurement
Checking the Current
Temperature
1.
Enter the Temperature Mode.
Navigating Between Modes
l
Entering the Temperature Mode will start
temperature measurement and display
the result.
After you enter the Temperature Mode,
●
the watch takes readings about every
five seconds for three minutes. After
that, a measurement is taken about
every two minutes.
To retrigger measurement, press (A).
●
Temperature
Note
If the hour and/or minute hand is
●
located over the digital display when
you perform a temperature
measurement, the hands will
temporarily shift to 4 o'clock or 8
o'clock to allow easier reading of
measurement values. The hands will
unshift to their normal positions after
about three seconds.
The watch will automatically return to
●
the Timekeeping Mode if you do not
perform any operation in the
Temperature Mode for about one hour.
The measuring range is -10.0 °C to
●
60.0 °C (14.0 °F to 140.0 °F) (0.1 °C
(0.2 °F) units). [- - .-] will appear for the
measured value if it is outside the
allowable range.
To return to the Timekeeping Mode,
●
hold down (B) for at least two seconds.
27