Solar Pump; Operating Data; Pump Status - Baxi SH 7 COMPACT Installation And Service Manual

8 Solar pump

8 Solar pump
8.1

Operating data

Fig.25 Solar pump operation panel
A
8.2

Pump status

28 Solar hydraulic unit
B C D E F
BA-0000152-01
The pump UPM3 Solar is a high-efficiency pump designed to function with
and without the PWM signal, therefore enabling the following curves:
3 Constant curves (functioning without PWM signal)
One PWM curve with solar profile C (stopping without PWM signal)
Importante
The pump is preset to curve with profile C PWM by default.
Importante
If the controller does not have an PWM output, do not connect the
signal cable and program the pump with constant curves.
The UPM3 Solar operation panel is designed with a single button, one red/
green LED and four yellow LEDs.
Tab.10 Solar pump operation panel
Pos. Description
A Press the button
B LED 1
C LED 2
D LED 3
E LED 4
F LED 5
The operation panel displays:
Control mode
Status of alarms.
If a pump has detected one or more alarms, LED 1 will change from green
to red and one of the other LEDs will go yellow. Refer to the faultfinding
information
If multiple alarms are active at the same time, the LEDs will only display
the highest priority error. The priority is defined by the sequence in the
table shown in the faultfinding information.
7729335 - 04 - 12052021