Stihl FS 56 Instruction Manual page 15

Mounting the Control Handle
4
3
1
2
Take out the screw (1) – the nut (2)
N
remains in the control handle (3).
Push the control handle onto the
N
handlebar (5) until the holes (6) line
up – the throttle trigger (4) must
point towards the gearbox.
Insert the screw (1) and tighten it
N
down firmly.
FS 56, FS 56 R, FS 56 C, FS 56 RC
Adjusting and securing the handlebar
6
Align the handlebar so that
N
distance A is about 20 cm (8 in) and
distance B about 15 cm (6 in).
Tighten down the screws (1) firmly
5
N
in a crosswise pattern.
6
Fitting the Throttle Cable
NOTICE
Do not kink the throttle cable or lay it in
tight radii – make sure the throttle trigger
moves freely.
A
1
B
2
1
2
Position the throttle cable
N
retainer (2) and throttle cable (1)
against the drive tube.
Close the throttle cable retainer (2).
N
The retainer (2) snaps into place.
English
1
13