ZKTeco QR500 How To Use
  1. Manuals
  2. Brands
  3. ZKTeco Manuals
  4. Control Systems
  5. QR500
  6. How to use

ZKTeco QR500 How To Use

Hide thumbs
1
2
3
4

Advertisement

Table of Contents

SHENZHEN ISECUS ELECTRONIC CO., LTD
Add: Room 218A, No. 7, YaYuan Road, BanTian Town, LongGang Area, Shenzhen, China 518129
www.isecus.com
sales@isecus.com
How to use QR500 in ZKTeco Access Control System?

Introduction

QR500 from ZKTeco is a new generation of intelligent reader with verification of QR code and 13.56MHz Mifare
cards and cellphone NFC as well. It has fast scanning speed, high recognition rate, High compatibility, and can
be connected to any access controller that supports Wiegand input. It also support the RFID Functions, like
13.56MHz Mifare Ultralight / DESFire EV1, NTag, So that it can be applied in community management, visitor
management, hotel management, unmanned supermarkets and so on.
As a slave reader, QR500 can connect with ZKTeco access controllers and biometric access control terminals
through wiegand and RS485 ports.
Supported Popular Model:
Access Controller: C3-100, C3-200, C3-300, Inbio160, Inbio260, Inbio460
RFID & Biometric Access Control: SC700, F18, F19, F21, F22, TF1700, SF300, SF400, iFace, UFace, MiniAC Plus,
SpeedFace V5L, ProfaceX, etc.
1. Installation Diagram about QR500 connection with ZKTeco Access Control and Control Panel
Can replace
to other ZK
models like
Inbio, F18,
QR500
QR500

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the QR500 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for ZKTeco QR500

Summary of Contents for ZKTeco QR500

  • Page 1 How to use QR500 in ZKTeco Access Control System? Introduction QR500 from ZKTeco is a new generation of intelligent reader with verification of QR code and 13.56MHz Mifare cards and cellphone NFC as well. It has fast scanning speed, high recognition rate, High compatibility, and can be connected to any access controller that supports Wiegand input.
  • Page 2 SHENZHEN ISECUS ELECTRONIC CO., LTD Add: Room 218A, No. 7, YaYuan Road, BanTian Town, LongGang Area, Shenzhen, China 518129 www.isecus.com sales@isecus.com 2. Wiring Diagram on QR500 and Access Control WG0/WG1 Example: C3-100 with QR500...
  • Page 3 ZKTeco Biometric Access Control devices, by default, it is set with Wiegand 26. When working with QR500, please set the device to Wiegand 34. Note: If there is no response on Master device when you wave card or scan QR code on QR500, please check the Wiegand input Format in ZKTeco Device.
  • Page 4 6. FAQ about QR500 Application 1). Q: Can the QR500 reader scan QR code and scan RFID at the same time? A: You can't verify both QR cide and RFID card at the same time. You can only verify either RFID card or QR code at one time.

Table of Contents