Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for ZKTeco CMP-100A
Summary of Contents for ZKTeco CMP-100A
- Page 1 User Manual CMP-100A Version: 1.0 Date: May 2019 1 F16 Quick Start Guide...
-
Page 2: Table Of Contents
Contents 1 Performance Features of the Product................................1 1.1 Movement features ...................................... 1 1.2 Control System ........................................ 1 1.3 Safety Features ......................................... 2 2 Product Specifications and Structural Parameters ..........................3 2.1 Specifications........................................3 2.2 Technical Specifications ..................................... 3 2.3 Working Principle ......................................3 2.3.1 Movement Structure .................................. -
Page 3: Performance Features Of The Product
The product adopts an imported photoelectric isolation protection circuit to ensure complete signals and resistance to strong interference. The product integrates a high-performance wireless remote control receiving module with one million groups of learning codes to ensure stable operation. CMP-100A User Manual 1... -
Page 4: Safety Features
Rubber strip anti-smash: The gate bar is equipped with a rubber strip, which can mitigate the loss caused by accidents. 2 CMP-100A User Manual... -
Page 5: Product Specifications And Structural Parameters
Through a magnet induction switch, the locations of the gate bar in the horizontal and vertical states during operation are accurately determined to realize control over the gate bar. CMP-100A User Manual 3... -
Page 6: Movement Structure
When the length of the gate bar is changed, adjust the pull hole of the spring again, as shown in the figure. Pull holes of the spring, as shown in the figure below: 4 CMP-100A User Manual... - Page 7 Arm hole for a 6m bar Arm hole for a 5m bar Arm hole for a 4.5m bar Arm hole for a 4m bar CMP-100A User Manual 5...
-
Page 8: Product Dimensions
2.4 Product Dimensions 6 CMP-100A User Manual... -
Page 9: Wiring Diagram
2.5 Wiring Diagram CMP-100A User Manual 7... -
Page 10: Installation And Commissioning
Embed cables or dig a cable trench to bury cable pipes between the central point of the chassis position and the control room or watch house, guide the 3x1.5 mm2 power cable and 4x0.5 8 CMP-100A User Manual... - Page 11 After the barrier gate is firmly installed, connect cables for the chassis and connect control cables for related peripheral equipment by following the wiring diagram of the control panel of the barrier gate and perform related commissioning. CMP-100A User Manual 9...
-
Page 12: Operation And Maintenance Instructions
Wipe off dust and oil stains on the surface of the chassis using a soft fine cloth and keep the surface of the chassis clean. Regularly check whether cable connections on the control panel are not loose or the contact is proper and 10 CMP-100A User Manual... -
Page 13: Fault Analysis And Troubleshooting
15 Ω to 30 Ω or underground cable. resistance exists. (5) Measure the temperature of the motor by using a Start the product after thermometer determine whether the motor cools down. temperature is above 130°C. CMP-100A User Manual 11... - Page 14 The gate bar shakes Adjust the tension of the a lot when it falls Check whether the balanced spring is too loose or spring or replace the onto the specified too tight. spring. position. 12 CMP-100A User Manual...
- Page 15 ZKTeco Biometrics India Pvt. Ltd. Global R&D Centre Survey No 01/01, Outer Ring Road, Mahadevpura, Bengaluru, Karnataka – 560048 Phone: 080-68281342/48 | Email: sales@zkteco.in | Website: www.zkteco.in CMP-100A User Manual 13 Copyright©2019 ZKTECO CO., LTD. All rights reserved.