Advertisement

Installation Guide
PB4060
Version: 1.0
Date: July 2018
Contents
I

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the PB4060 and is the answer not in the manual?

Questions and answers

Summary of Contents for ZKTeco PB4060

  • Page 1 Installation Guide PB4060 Version: 1.0 Date: July 2018 Contents...
  • Page 2: Table Of Contents

    Contents Chapter 1 Cable Embedding ..............................1 Chapter 2 Cabinet Installation ............................2 Chapter 3 Boom Installation ..............................3 Chapter 4 Cabinet Inside ............................... 4 Chapter 5 Troubleshooting ..............................6...
  • Page 3: Chapter 1 Cable Embedding

    Chapter 1 Cable Embedding Prepare φ25 protective sleeve and cable in advance.  Route cables to be connected through protective sleeves.  Use a tool to open a cable tray on the ground, see Figure 1-1.  Cabinet Expansion bolt 4-M12 Control Screw pad...
  • Page 4: Chapter 2 Cabinet Installation

    Drive four expansion bolts into the bolt holes, as shown in Figure 2-1.  Install screw pads and use a wrench to tighten nuts, as shown in Figure 2-2.  Figure 2-1 Cabinet Chassis Expansion bolt Screw pad Ground Ground Base concrete Figure 2-2 PB4060 Installation Guide...
  • Page 5: Chapter 3 Boom Installation

    Chapter 3 Boom Installation Pull the vice boom out from the main boom, then fastened by 2 screws, as shown in  Figure3-1. Installing the boom to the chassis, as shown in Figure 3-2.  Figure 3-1 Connect the main boom with vice together by 2 screws Figure 3-2 Installing the Boom to the cabinet Chapter 3 Boom Installation...
  • Page 6: Chapter 4 Cabinet Inside

    Copy/delete key: (Copy) press the key, and then press any other key of remote controller until the Copy/delete indicator light blinking. (Delete) press the key until the Copy/delete indicator light blinking, then press the Stop of testing key. AC power input: Connection with 110/220V power according to type of your purchasing. PB4060 Installation Guide...
  • Page 7 Mechanism core  Figure 4-2 Sensor: The sensor on the bottom of motor. It is using for that if the boom falling down press any other obstacles, the boom will lifted up automatically. Motor: AC power motor Hall sensor: Connect to Limited switch port of control board, which limited the close/open position. Shock absorber: A gel is used to absorb the pressure of close/open boom Spring: Using it to keep balance with boom.
  • Page 8: Chapter 5 Troubleshooting

    B. The plug of sensor did not connect correctly. The distance of remote controller The battery of remote controller no power, decrease. change a new battery. Attention: please make sure the power input match with device. PB4060 Installation Guide...

Table of Contents