Platform Specifications - Cisco 2650XM Datasheet

All contents are Copyright © 1992–2007 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information.
Table 8 identifies other Cisco IOS Software features
●
Table 9 lists the Cisco Mobile Wireless Transport Manager 6.0 features
●
Table 1. Protocol Compliance
Protocol
Message Transfer Part (MTP) 1,2,3
SCCP
TCAP
High-speed link (ATM over
nonchannelized T1 or E1)
High-speed link (nonchannelized T1 or E1) Q703 Annex A
MTP2-User Peer-to-Peer Adaptation Layer
(M2PA)
M3UA
SUA
SCTP
MAP
The Cisco ITP MTP2 and MTP3 layers have been tested for STP conformance by Telcordia Technologies.

Platform SpecIFIcations

The Cisco IP Transfer Point is implemented on the Cisco 2600XM Series Router
and 2651XM), the Cisco 2811 Router, the Cisco 7200 Series Router (Cisco 7204VXR and
7206VXR), the Cisco 7301 Router, and the Cisco 7500 Series Router
hardware models function similarly by performing MTP3 and Signaling Connection Control Part
(SCCP) routing over SS7 TDM links or over an IP (or dual IP) network. The scope of this data
sheet is specific to the Cisco 2600XM and 7500 Series Routers. Please reference additional Cisco
ITP data sheets for information regarding the additional supported hardware platforms described
above.
RAM and Flash memory requirements are determined by operational requirements for
Note:
maximum capacity. Cisco IOS Software images, routing tables, Global Title Translations (GTTs),
and run-time data structures consume memory.
Table 2. General Platform Specifications
Attribute Cisco 2650/2651XM
Dimensions 1.69 x 17.5 x 11.8 in.
(H x W x D) (4.3 x 44.5 x 30 cm)
Rack units (RU) 1 RU
Dual processor No
Dual power Yes, external
Network Equipment No
Building Standards
(NEBS) 3
Main processor
requirements
Main processor RAM 128 MB
1
The Cisco 2600XM Series Router reached end-of-sale March 27, 2007.
2
The Cisco 7500 Series Router will reach end-of-sale December 15, 2007.
Specifications
ITU-T Q.701-Q.709 White 1996 (interworks with Blue), ANSI 2 T1.111-1996,
China SS7, Japan TTC, JT-Q704 (v3 2002/5/30), JT-Q703(v3 1994/4/27), JT-
Q702 (v1 19874/28), JT-Q701 (v2 1990/11/28)
ITU-T Q.711-Q.719 White 1996 (interworks with Blue), ANSI T1.112-1996
ANSI TCAP – T1.114 1996, ITU-T Q771–775 (White book, June 1997)
Q.2100, Q.2140, Q.2110, Q.2210, Q.2144, JT-Q2210, JT-Q2140, JT-Q2110,
JT-I363.5/JT-QI361, GR-2878, I.363.5, I.361
IETF RFC 4165: SIGTRAN SS7 MTP2-User Peer-to-Peer Adaptation Layer
IETF RFC 4666: SIGTRAN SS7 MTP3-User Adaptation Layer
IETF RFC 3868: SIGTRAN SS7 SCCP-User Adaptation Layer.
IETF RFC 2960: Stream Control Transmission Protocol
IETF RFC 3309: Stream Control Transmission Protocol Checksum Change
03.40 ETSI Document TS 100 901 v7.5.0
Cisco 7507
19.25 x 17.5 x 25.1 in. (48.9 x
44.45 x 63.75 cm)
11 RU
Yes
Yes
Yes
Route Switch Processor (RSP)
8 or 16
512 MB
Data Sheet
1
(Cisco 2650XM
2
(Cisco 7507 and 7513). All
Cisco 7513
33.75 x 17.5 x 22 in. (85.73 x
44.45 x 55.88 cm)
20 RU
Yes
Yes
Yes
RSP 8 or 16
512 MB
Page 3 of 11