Cisco 1811W Release Note page 11

To remove the login banner, enter the following command:
Step 8
yourname(config)# no banner login
The login banner warning will no longer appear.
To remove the exec banner, enter the following command:
Step 9
yourname(config)# no banner exec
The exec banner warning will no longer appear.
Leave configuration mode, by entering the following command:
Step 10
yourname(config)# end
Copy the configuration changes to the startup configuration by entering the following command:
Step 11
yourname# copy running-config startup-config
When logging into the router in the future, use the username and password that you created in
Cisco CP Express May Not Operate with Custom Configuration File
If you load a custom configuration file on the router usingCisco CP Express or any other process, you
may remove Command Line Interface (CLI) commands that Cisco CP Express operation requires and
prevent it from operating. Cisco CP requires the following basic configuration in order to connect to the
router and manage it.
•
•
•
•
•
The following example shows a configuration that contains the CLI commands Cisco CP Express
requires in order to operate.
hostname yourname
!
logging buffered 51200 warnings
!
username fish privilege 15 secret 0 salmon
!
ip domain-name yourdomain.com
!
interface FastEthernet0
description $ETH-LAN$$ETH-SW-LAUNCH$$INTF-INFO-10/100 Ethernet$
ip address 10.10.10.1 255.255.255.248
description PC must be on the same subnet as this interface
no shutdown
!
ip http server
ip http secure-server
OL-16652-01
An http or https server must be enabled with local authentication.
A local user account with privilege level 15 and accompanying password must be configured.
Vty line with protocol ssh/telnet must be enabled with local authentication. This is needed for
interactive commands.
An http timeout policy must be configured with the parameters shown in the following example to
avoid a known launch issue with Cisco CP Express.
The PC on which Cisco CP Express is to run and the interface through which Cisco CP Express will
be launched must be configured with IP addresses from the same subnet.
Release Notes for Cisco Configuration Professional Express 1.0
Important Notes
Step 6.
11