Flex FX2131A Operator's Manual page 16

SAW-DUST EXTRACTION (FIG. 8)
WARNING
To extract saw dust created during cutting,
connect a suitable vacuum cleaner with a 1-1/4"
suction hose to the vacuum hose adapter.
Make sure that the vacuum hose has freedom
to move and has enough length to complete
the cut. If needed, have another person move
the vacuum cleaner and the hose while you are
making the cut.
Before starting a cut, make sure that the airflow
through the upper guard is not obstructed.
When not using a vacuum while cutting, the
vacuum hose adapter can be oriented away
from the operator, as shown in Fig. 8.
SAW HOOK (FIG. 9)
Your tool is equipped with a hook. Use the hook
to hang the saw from a rafter or beam or other
similar secure structure for temporary storage
during work. Recommended lumber size to
support the saw with the hook: 2X4.
To use, lift up the hook until it snaps into the
open position.
When not in use, always lower the hook until it
snaps into the closed position.
WARNING
saw or the object that it is hanging from. Do
not hang the saw from any electrical wires.
Make sure that the structure used to hang
the saw is secure. Personal injury or property
damage may occur.
Only use the hook for hanging the saw.
Using the hook to hang anything else could lead
to serious injury.
Do not use the hook to reach another object
or use the hook to support your weight in
any situation.
Always wear a dust mask
during use.
When the saw is hung by
the hook, do not shake the
Fig. 8
Fig. 9
-16-
Vacuum Hose
Adapter
Ø1-1/4"
(31.8 mm)
Saw Hook