Adjustments; Adjust Control Manifold Relief Valves - Toro Reelmaster 3550-D Preliminary Service Manual

Adjustments

Adjust Control Manifold Relief Valves

The hydraulic control manifolds on your Reelmaster in-
clude adjustable relief valves. The following procedure
can be used to adjust these relief valves.
NOTE: Do not remove relief valve from the hydraulic
manifold for adjustment.
1. Locate relief valve on control manifold.
1
2. Remove cap on relief valve with an allen wrench.
3. To increase pressure setting, turn the adjustment
socket on the valve in a clockwise direction. A 1/8 turn
on the socket will make a measurable change in relief
pressure.
4. To decrease pressure setting, turn the adjustment
2
socket on the valve in a counterclockwise direction. A
1/8 turn on the socket will make a measurable change
in relief pressure.
5. Install and tighten cap on relief valve.
6. Recheck relief pressure and readjust as needed.
Figure 19
1. Relief valve cap 2. Adjustment socket
Reelmaster 3550--D Page 4 - - 17 Hydraulic System