General; About This Manual - Yaesu FT-5100 Technical Supplement

About This Manual

The information in this manual is intended
to supplement the FT-5100 Operating Manual,
for servicing the transceiver. Specifications
and details of operation and options are pro­
vided in the operating manual, and are not
reprinted herein. Therefore, this manual is not
intended to serve as an independent reference,
but to be used in conjunction with the informa­
tion provided in the operating manual. The
FT-5100 is intended to be serviced only by
qualified technicians.
Two pcb layout diagrams are provided for
each double-sided circuit board in the trans­
ceiver. Each side of the board is referred to by
the type of the majority of components in­
stalled on that side ("leaded" or "chip-only").
In most cases one side has only chip compo­
nents, and the other has either a mixture of
both chip and leaded components (trimmers,
FT- 5100 Technical Supplement

General

coils, electrolytic capacitors, ICs, etc.), or
leaded components only.
While we believe the technical information
in this manual is correct, Yaesu cannot assume
any liability for damage that may occur as a
result of typographical or other errors that
may be present. Your cooperation in pointing
out any inconsistencies in the technical infor­
mation would be appreciated.
The technical information in this manual
supercedes all previously published informa­
tion on this product. Where information is du­
plicated in this manual and the operating
manual, this manual should generally be con­
sidered more current.
Yaesu Musen reserves the right to make
changes in the circuitry of this transceiver, in
the interest of technological improvement,
without obligation to owners.
1 -1