Table of Contents
Advertisement
2.1
Connecting to the modem
Should you run into any issues connecting to the modem, refer to the
Click on Tools > Settings > Connection tab to select the interface your PC will use to connect to the modem.
2.1.1
Using a serial cable:
1)
Select Serial
2)
Select the COM port in the dropdown list, then click OK
2.1.2
Using an Ethernet or USB cable:
3)
Select Modem IP
4)
Enter the appropriate modem IP then click OK. By default, the DHCP-assigned IPs will be 192.168.0.1 for Ethernet
and 192.168.111.1 for USB. If using USB, the BlueTree RNDIS driver must be installed as explained in the
Interface Specifications
2.1.3
Connecting to a remote modem:
5)
Select Remote Configuration and click OK. A new panel will open to the left of BlueVue Device Manager.
6)
Right-click Available Modems in the panel
Click Add...
7)
Enter the modem's information, then click OK. The description is optional.
8)
Figure 4 – The different ways to connect to a modem
section.
BlueVue Device Manager Troubleshooting
appendix.
Data
Advertisement
Table of Contents
