Steps
1. Slide and insert the 3.5-inch hard-disk drive into the hard-disk drive slot.
2. Replace the fours (#6-32) screws to secure the hard-disk drive to the chassis.
3. Route the power cable and the data cable through the routing guides and connect the cables to the hard-disk drive.
Next steps
1. Install the
side
cover.
2. Follow the procedure in
Solid-state drive
Removing the M.2 2230 PCIe solid-state drive
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
3. Remove the
fan
duct.
About this task
The following images indicate the location of the solid-state drive and provide a visual representation of the removal procedure.
22
Removing and installing components
after working inside your
before working inside your
computer.
computer.