Behringer XENYX QX1202USB Quick Start Manual page 17

PHONES/CONTROL ROOM – The stereo
(16)
PHONES jack (at the top of the connector
panel) is where you connect headphones.
The unbalanced CTRL ROOM OUT jacks carry
the summed effects and main mix signals, as
well as soloed channel signals. The PHONES/
CONTROL ROOM control adjusts the level of
both headphones and main monitor outputs.
MAIN MIX – The MAIN OUT connectors are
(17)
balanced mono jacks. The main mix signal
appears here at a level of 0 dBu. The MAIN MIX
fader adjusts the volume of these outputs.
CD/TAPE INPUT – The CD/TAPE INPUTs
(18)
are used to bring an external signal source
(e.g. CD player, tape deck, etc.) into the
console. They can also be used as a standard
stereo line input, so the output of a second
XENYX or BEHRINGER ULTRALINK PRO MX882
can be connected.
CD/TAPE OUTPUT – These connectors are
(19)
wired in parallel with the MAIN OUT and carry
the main mix signal (unbalanced). Connect
the CD/TAPE OUTPUT to the inputs of your
recording device. The output level is adjusted
via the high-precision MAIN MIX fader.
USB/2-TR TO PHONES/CTRL RM
(20)
button routes USB/2-Track playback to
PHONES/CTRL ROOM.
USB/2-TR TO MAIN MIX button routes
(21)
USB/2-Track playback to MAIN MIX and mutes
the 2-TR OUT/USB recording signal.
FX TO CTRL ROOM – If you want to monitor
(22)
only the FX send signal in your headphones
or monitor speaker(s), press the FX TO CTRL
switch. This mutes the main mix signal while
routing the FX SEND output to the monitor(s).
+48 V – The +48 V LED lights up when
(23)
phantom power is on. The PHANTOM switch
activates the phantom power supply on the
XLR connectors of all mono channels.
POWER – The POWER LED indicates that the
(24)
console is powered on.
LEVEL INDICATOR – The high-precision
(25)
4-segment display accurately displays the
relevant signal level.
SIGNAL and CLIP LED – The SIGNAL LED on
(26)
the effects module shows the presence of a
signal whose level is high enough. This LED
should always be on. However, make sure
that the CLIP LED lights up only sporadically.
If it is lit constantly, you are overdriving the
effects processor, which leads to unpleasant
distortion. If this occurs, turn the FX controls
down somewhat.
PROGRAM – The PROGRAM control has two
(27)
functions: by turning the PROGRAM control,
you dial the number of an effect. The number
of the preset you just dialed up blinks in the
display. To confirm your selection, press the
PROGRAM control; the blinking stops.
COMP – This knob adjusts the amount of
(28)
compression effect on the channel.
PHANTOM – Press this button to send +48 V
(29)
of phantom power to the XLR inputs for use
with condenser microphones.
USB CONNECTOR – Connect your mixer to a
(30)
computer using a standard USB cable.
AC POWER IN – Connect the included power
(31)
cable here.
!
The mixer cannot be bus-powered via USB. Always
use the included power adapter to supply power to
the mixer.
17
Quick Start Guide