Mitsubishi Electric V-251BZ-HK Installation Manual page 9

Bathroom thermo ventilator
Hide thumbs Also See for V-251BZ-HK:
Table of Contents

Advertisement

Note / 備註
- Check that the protruding parts of the main unit
are fit into the holes of the duct connection port
catch. (If the protruding parts are not fit into the
holes, the connection could be insufficient and
could cause air leakage)
- 檢查主機的突出部分是否插入管道連接口卡口的孔
中。(如果突出部分未插入孔中,則可能會因連接不良
而導致漏氣)
- Install the main unit on the ceiling from inside the
bathroom. Otherwise maintenance of the main
unit becomes impossible.
- 將主機從浴室內部安裝到天花板上。否則無法對主機
進行維護。
- Do not cover the surface of the main unit with
heat-insulating materials. Also, ensure that heat-
insulating materials are at least 100 mm away
from the main unit.
- 請勿使用隔熱材料覆蓋主機表面。另外,確保隔熱材
料離開主機至少100 mm。
- Check that all mounting screws are tightened in
the suspension support frame.
- 檢查懸掛支撐框架上的所有安裝螺釘是否擰緊。
4. Install the panel.
4. 安裝面板。
(1) Turn the fixing clips between the panel and panel
base at the left and right sides.
(1) 轉動左右兩側面板與面板底座之間的固定夾。
Panel closed
面板關閉
(2) Open the panel and remove it from the panel base.
(2) 打開面板,將其從面板底座上拆下。
Panel
面板
Panel base
面板底座
Panel
面板
Fixing clip
固定夾
Panel open
面板打開
Panel base
Panel
面板底座
面板
Push here to remove
按此處拆下
Panel base
面板底座
(3) Attach the panel base to the main unit using the
four panel mounting screws (4 x 10) supplied.
(3) 使用隨附的四個面板安裝螺絲(4 x 10)將面板底座安
裝到主機上。
Note / 備註
- Do not use an impact driver to tighten the screws
in the panel base. Tighten by hand.
- 請勿使用衝擊起子緊固面板上的螺絲。請用手緊固。
(4) After installing the panel, close the panel.
Attach the panel to the panel base. After closing the
panel, turn the fixing clips to secure the panel.
(4) 安裝面板後,關閉面板。
將面板安裝到面板底座上。關閉面板後,轉動固定
夾以固定面板。
Panel base
面板底座
Push here to attach
按此處裝上
Panel
面板
A protective sheet is attached to the front surface of the
controller on the main unit. Peel off the protective sheet.
主機控制器正面上貼有保護膜。請撕掉保護膜。
Adhesive tape
膠帶
Protective sheet
保護膜
Stick commercial adhesive tape to a corner of the protective
sheet, as shown above, and peel off the protective sheet.
如上圖所示,將市售的膠布貼到保護膜的一角上,然
後撕掉保護膜。
9
Main unit
主機
Panel base
面板底座
Panel mounting screw
面板安裝螺絲
Panel base
面板底座

Advertisement

Table of Contents
loading

Table of Contents