3-axis handheld gimbal for smartphone manual (21 pages)
Summary of Contents for FeiYu Tech WG2
Page 1
1. Download the USB driver from FeiyuTech official website http://www.feyu-tech.com and install it. Then download the upgrade software and the firmware for WG2. 2. Please refer the following connection diagram, connect the USB cable with USB port of the computer and the gimbal. please make sure the gimbal is powered off until step 7.
Page 2
Guilin Feiyu Technology Incorporated Company 3. Check the port number in device manager .If the port number is more than COM10 , please modify it to available number which is within COM10 . 4. Run the software ---“Gimbal-Update-3AXIS” directly if you have a PC with Windows XP/7/8/8.1 .
Page 3
Guilin Feiyu Technology Incorporated Company 6. Choose correct port number and correct baud rate as 115200, then click on OPEN button to open COM port.(The serial port number should be the same as step 3). 7. Long press the function button, The connection between the gimbal and the computer will be established automatically, The connection status and the current version show up(For example, “LINK OK! VERSION 1.
Page 4
Guilin Feiyu Technology Incorporated Company OPEN FILE button and choose the correct firmware for the 8. Click on UPDATE button to start upgrading, the process will display 9. Click on on the software. 10. After all the blocks of the firmware are completely sent , please click on Confirm button to finish the upgrade.
Page 5
Guilin Feiyu Technology Incorporated Company NO.1 “Link OK ”didn’t show up when pressing the function button. ① Please check whether tightly plug in USB cable with USB port, and the USB cable is right cable from our standard accesseries. ② Please check whether keep the gimbal off until step7. ③...