FeiYu Tech Vimble C Firmware Upgrade Manual

Firmware Upgrade Manual

Attention :

 Please do not operate any other function button except the ones indicated by

the instructions during upgrade.

 The firmware upgrade software is compatible with Windows operation system

provisionally,including Window XP / 7 / 8 / 8.1 / 10.

If you want to upgrade it in Mac, Please kindly download the upgrade software

and USB driver for Mac from our official website.

If you want to get the current version of the gimbal, please do the operations

step 1~6.

1. Download the USB driver from FeiyuTech official website

http://www.feyu-tech.com

and the firmware for Vimble c.

2. Please refer the following connection diagram, connect the USB cable with

USB port of the computer and the gimbal. Check the port number in device

manager .

If the port number is more than COM10 , please modify it to the available

number which is within COM10 . ( please make sure the gimbal is powered off

until step 6)

Guilin Feiyu Technology Incorporated Company

Vimble c Gimbal

and install it. Then download the upgrade software

- 1 -

www.feiyu-tech.com

service@feiyu-tech.com

Table of Contents

Need help?

Do you have a question about the Vimble C and is the answer not in the manual?

Page 1 Then download the upgrade software and the firmware for Vimble c. 2. Please refer the following connection diagram, connect the USB cable with USB port of the computer and the gimbal. Check the port number in device manager .
Page 2 Guilin Feiyu Technology Incorporated Company 3. Run the software ---“Gimbal-Update-3AXIS” directly if you use a PC with Windows XP/7/8/8.1 . If you have a PC with windows10 operation system, please right click the icon of the software ,choose “Trouble shoot compatibility”---”Try the recommended settings”---”test program”, Run the upgrade software in compatibility mode.
Page 3 Guilin Feiyu Technology Incorporated Company Release it, the indicator will alternately flashing blue and red， Which means the power is ready and the connection is done. (Tips: if you can’t see that the indicator alternately flashing blue and red, please long press the function button for 2 seconds again.) OPEN FILE 7.
Page 4 Guilin Feiyu Technology Incorporated Company 9. After all the blocks of the firmware are completely sent , please click “Confirm” button to finish the upgrade. Close the software then remove the USB cable. Long press the function button of the gimbal to power off. All the upgrade is done. ––––...