Exido 245-092 Manual page 25

o Do not fill the appliance above
the middle mark on the inside
of the jug (115 ml). Always
ensure that the amount of milk
exceeds the bottom mark.
4. Check that the silicone seal (2) is
correctly fitted to the lid and seals
properly.
5. Close the lid and ensure that it
clicks into place.
6. Place the appliance on the base
and connect the appliance.
7. Start the appliance by holding
down the "start/pause" button for
approximately 2 seconds. The top
indicator lamp will be lit and the
appliance starts frothing the milk.
8. The appliance will turn off
automatically a few seconds
after the frothing of the milk has
completed (it takes about 65
seconds).
9. Remove the plug from the socket
once you have finished using the
appliance.
10. Clean all parts before storing the
appliance. See "Cleaning".
Tip: The stirrer and the whisk can be
stored in the holder on the inside of the
lid when not in use.
CLEANING
When cleaning the appliance, you
should pay attention to the following:
• Remove the plug from the mains
socket, and allow the appliance
to cool down completely before
cleaning it.
• Never immerse the base of the
appliance, the cord or plug in water,
and make sure no water enters the
base.
• Clean the appliance and the
accessories carefully after each
use.
o Clean the whisk and stirrer in
warm soapy water. Rinse the
parts in clean water and leave
them to dry.
o Fill the jug with warm water
and leave it to stand for a
couple of minutes. Empty the
jug and wipe it with a clean
damp cloth. Wipe dry with a
dry cloth or tea towel.
o The appliance and accessories
are not dishwasher-safe.
• Do not use scouring pads, steel
wool or any form of strong solvents
or abrasive cleaning agents to
clean the appliance, as they can
damage the external surfaces of
the appliance.
• IMPORTANT! Allow to dry
completely after cleaning. The
appliance must not be used if the
base or the bottom of the jug is
wet.
• Always clean the appliance before
putting it away if it is not to be used
for a prolonged period.
25