Danby DDW1804EW Owner's Manual page 6

INSTALLATION INSTRUCTIONS
WIRING CONNECTION INSTRUCTIONS
Before connecting the power cable to the
dishwasher, make sure the circuit breaker is off.
In the junction box located at the front bottom right
of the dishwasher, fi nd the three power wires from
the dishwasher including the grounding line.
Pass the power cable through the strain relief, and
then into the junction box.
Connect the black wire of the dishwasher to the
black wire of the power cable by inserting both into
a wire nut and then rotating the wire connector.
Connect the white wire to the white wire and the
green to the green in the same manner.
Recheck each wire to ensure it is connected correctly
and securely.
Each colored wire should be connected to the
corresponding wire of the same color.
White should be connected to white, black to black,
and green to green.
Replace the junction box cover on the dishwasher.
Recheck each wire to ensure it is connected
correctly and securely. Each coloured wire should
be connected to the corresponding wire of the same
colour.
WARNING ELECTRICAL SHOCK HAZARD
To avoid electrical shock, do not work on an
energized circuit. Doing so could result in serious
injury or death. To avoid a fi re hazard, make sure
electrical work is properly installed. Only qualifi ed
electricians should perform electrical work.
1. Junction box
2. Power cable
3. Black to black
4. White to white
5. Green to green (ground to ground)
6. Strain relief
1
6
5
3
4
2
5