Table of Contents
Advertisement
Quick Links
1455 Kleppe Lane Sparks, NV 89431-6467 (775) 359-4712 Fax (775) 359-7424
Model H1011.8HO/H1011.8HO2
NOTE TO INSTALLER: Please leave this information with the Maintenance Department.
Haws electric water coolers are not designed or recommended for outdoor or corrosive
environments such as enclosed chlorinated pool areas.
Consideration must be made at the time of installation to adhere to state and/or local
codes and environmental/atmospheric conditions such as, but not limited to, dust,
corrosion, freezing etc. These conditions will void the warranty.
CAUTION! Prior to making any electrical connections, verify with a voltmeter that power
from the service panel is off.
HAWS warrants that this specific product is guaranteed against defective material or
poor workmanship for a period of one year from date of shipment. HAWS liability
under this warranty shall be discharged by furnishing without charge F.O.B. HAWS
Factory any goods, or part thereof, which shall appear to the Company upon
inspection to be of defective material or not of first class workmanship, provided that
claim is made in writing to Haws within a reasonable period after receipt of the
product. Where claims for defects are made, the defective part or parts shall be
delivered to the Company, prepaid, for inspection. HAWS will not be liable for the
cost of repairs, alterations or replacements, or for any expense connected therewith
made by the owner or his agents, except upon written authority from HAWS,
Sparks, Nevada. HAWS will not be liable for any damages caused by defective
materials or poor workmanship, except for replacements, as provided above. Buyer
agrees that HAWS shall not be liable for general, special, or consequential damages
claimed to arise under the contract of sale. The drinking fountain manufactured by
HAWS is warranted to function if installation and maintenance instructions provided
are adhered to. The units also must be used for the purpose for which they were
intended.
NO OTHER WARRANTIES EXPRESSED OR IMPLIED ARE AUTHORIZED,
PROVIDED OR GIVEN BY HAWS.
05/21
E-mail:
haws@hawsco.com
Water Cooler
LIMITED WARRANTY
MODEL H1011.8HO/H1011.8HO2
website:
www.hawsco.com
No. 0002080250 (28)
PAGE 1 OF 10
Advertisement
Table of Contents
Related Manuals for Haws H1011.8HO
Summary of Contents for Haws H1011.8HO
- Page 1 Haws within a reasonable period after receipt of the product. Where claims for defects are made, the defective part or parts shall be delivered to the Company, prepaid, for inspection.
-
Page 2: Parts List
H1011.8HO2 with 2RKHO.H: 100-277VAC x 9VDC, 50-60Hz, 5 Watts. MAINTENANCE: Periodically clean strainers (One is inside push button valve on Model H1011.8HO (refer to 5874 Series Valve Manual for details) & other is on inlet side of chiller). PARTS LIST... -
Page 3: Installation Procedure
INSTALLATION PROCEDURE GENERAL NOTES: The Model H1011.8HO/H1011.8HO2 Water Cooler Assembly requires installation of the mounting frame as described in Steps 1 – 2, then mounting the fountain bowl assembly as described in Steps 3 – 6, and finally completing chiller water and electrical connections and starting chiller per Steps 7 –... - Page 4 Remove slip joint nuts from bottom of fountain waste outlet. Assemble nut over 1- 1/4” O.D. end of waste elbow as supplied by Haws. Assemble waste elbow onto bowl waste body using seal washer provided and tighten nut hand tight. Measure vertical distance down to trap inlet and cut the vertical (not supplied) elbow to length allowing 1/2"...
-
Page 5: Maintenance
STEP 9: Model H1011.8HO (only): 5874 Series Valve - Adjust bubbler stream height using a small flat-head screwdriver inserted through a hole in the center of the push button for increased flow turn clockwise and for decreased flow turn counterclockwise. If flow problems arise, see troubleshooting guide for additional instructions to correct problem. -
Page 6: Repair Checklist
For more information about Haws products, see our website: www.hawsco.com Corporation – All Rights Reserved ® © 2021 Haws ® HAWS and other trademarks used in these materials are the exclusive property of Haws Corporation. 05/21 MODEL H1011.8HO/H1011.8HO2 PAGE 6 OF 10... -
Page 7: Parts Breakdown
WHEN ORDERING PARTS PLEASE SPECIFY MODEL NUMBER. 10/21/98 APPROVED DATE 05/13/21 PARTS BREAKDOWN SCALE: DRAWING TYPE: SIZE: A SHEET 2021 Haws Corporation - All Rights Reserved PAGE 7 OF 10 HAWS and other trademarks used in these materials are the exclusive property of Haws Corporation. - Page 8 WHEN ORDERING PARTS PLEASE SPECIFY MODEL NUMBER. 07/22/20 APPROVED DATE 05/13/21 PARTS BREAKDOWN SCALE: DRAWING TYPE: SIZE: A SHEET 2021 Haws Corporation - All Rights Reserved PAGE 8 OF 10 HAWS and other trademarks used in these materials are the exclusive property of Haws Corporation.
- Page 9 (ROUGH-IN DIMENSIONS APPLY TO BOTH MODELS WITH EXCEPTION NOTED ON SHEET 2) H1011.8HO/H1011.8HO2 DRAWN: DATE: CHK'D.: REVISION 07/97 APPROVED: DATE: 05/13/21 SCALE: DRAWING TYPE: INSTALLATION SIZE: A SHEET 2021 Haws Corporation - All Rights Reserved. HAWS and other trademarks used in these materials are the exclusive property of Haws Corporation.
- Page 10 (SEE SHEET 1 FOR APPLICABLE ROUGH-IN DIMENSIONS) DRAWN: DATE: CHK'D.: REVISION 07/22/20 APPROVED: DATE: 05/13/21 SCALE: DRAWING TYPE: INSTALLATION SIZE: A SHEET 2021 Haws Corporation - All Rights Reserved. HAWS and other trademarks used in these materials are the exclusive property of Haws Corporation.