Marley EM-JA019 Operating Instruction page 7

NOTE:
Long press Bluetooth & VOL- for 2S disconnect current TWS paired, enter BT pairing
mode
If no TWS device paired, after for 5 minutes, it will auto power off
Before carrying out TWS networking, the Bluetooth connection of the speaker must be
disconnected. After successful networking, the pair can be matched again
4. Turn on the Bluetooth function on your external device
NOTE: The effective distance between your external device and this speaker is 10 meters
(33ft.)
5. Wait moment for "Get Together Duo x 2"
Duo x 2" to connect the speaker.
NOTE: Sometimes a window will ask you for a pass word. Fill in "0000" then press "OK" on
your external device.
6. After the Bluetooth pairing successful, voice prompt "PAIRED", the master device
indicator always lights up. Then you can select what you want to play on the external device.
7. Short press VOL+/ VOL - adjust the volume increase/decrease volume.
16 steps adjustable for volume level
NOTE: First power on for using, the default volume is 60%, after first usage, the volume
will memory the last time setting. Adjusted to the maximum volume, there will be a prompt
tone.
8. Long press VOL + or VOL - for 2 seconds it for the Next/previous track
9. Short press Bluetooth button music play/pause
10. Long Press Bluetooth button & VOL- together for 2 seconds, disconnect current Bluetooth
paired device and enter into Bluetooth pairing mode, blue indicator flash.
NOTE:
During the TWS mode playing, the slave device disconnect paired, can press the Bluetooth
button on the master device for 2 seconds to reconnect and pair.
In TWS mode, turn off the power and restart it, it will automatically enter TWS mode.
In TWS mode, to switch from other functions to Bluetooth functions, you need to press the
Bluetooth again to network.
Before TWS networking, it is recommended to pull out AUX-IN line and RCA cable.
TWS mode LINE IN play
You can also connect the AUX IN line and the RCA line to the external device and play in
TWS mode.
In TWS mode, LINE-IN and AUX-IN only output from the master device. Other operations
are the same as the use of a single speaker.
NOTE: In TWS mode,
to appear on the device list. Press
Aux-in is preferred only for the master device
"Get Together
blue LED