Line-In Mode - Marley EM-JA019 Operating Instruction

will memory the last time setting. Adjusted to the maximum volume, there will be a prompt
tone.
6. Long press VOL + or VOL - for 2 seconds it for the Next/previous track
7. Short press Bluetooth button music play/pause
8. Long Press Bluetooth button & VOL- together for 2 seconds, disconnect current Bluetooth
paired device and enter into Bluetooth pairing mode, blue indicator flash.
NOTE: Bluetooth paired, if no audio output, 15 min device will power off automatically
Bluetooth not paired 5 minutes will power off automatically

Line-in mode

You can connect the AUX IN line and the RCA line to the external device and play.
Use the AUX IN line
1. Connect one end of the AUX line into the AUX IN jack at the back of the unit.
2. Plug the other end of the line into the out socket of your external device.
3. Turn on the unit and your external device
4. Press the function button to switch to AUX IN function. The RED indicator went on.
5. During playback, Press VOL+ & VOL- buttons to adjust the volume level.
NOTE: In Bluetooth mode and LINE-IN mode, plug the AUX-IN cable, the AUX-IN will be
played first.
Use the RCA line (not include)
1. Use the one end of red speaker wire to plug it into red input jack of left speaker, the other
end to plug it into red output jack of external device.
2. Use the one end of black speaker wire to plug it into black input jack of left speaker, the
other end to plug it into black output jack of external device
Note: Be sure to match the color with the socket.
3. Turn on the unit and your external device.
4. Press the function button to switch to RCA function. The Purple indicator went on.
5. During playback, Press VOL+ & VOL- buttons to adjust the volume level.
USE TWO SPEAKERS (TWS MODE)
You can get a better sense of hearing by pairing two speakers together and using a
network
Connect the two speakers to make a whole
1. Power on the two speakers. Enter Bluetooth pairing mode.
2. Press the Bluetooth button on the master device for 2 seconds, open the TWS pairing. The
blue LED indicator flash 15-20 seconds.
3. When TWS are pairing, the solid blue indicator on the speakers will flash. TWS paired
successful, voice prompt "left channel" "right channel", the slave device solid blue stay lit. The
master device blue indicator continues flash.