Advertisement
Page 5 of 6
11. Click on the Port Tab on the top of the screen.
Change the preference to G.729
Uncheck the use all available Codec's for incoming calls
follow the preferences it has its own default values)
Click on the Submit Tab at the bottom of the page.
until the card has been rebooted)
12. Click on the Numbering Tab on the top of the screen.
Click on Add
Set Dialed Digit 2 to Point Code 1 and PBX to YES.
information it does not affect the operation).
Set Dialed digit 3 to Point Code 2 and PBX to NO.
13. Click on the Destinations Tab on the top of the screen
Click on Add
Set point Code 1 to IP Address 192.168.1.100, the ports section to PBX, the trunk
number to 1, and the comments is just for information.
Set Point Code 2 to IP Address 192.168.2.150, the ports section to 8, the trunk number
to the first trunk on the IAD card from MB 7-1, and the comments is just for information.
14. Click on the System Tab.
Click on Reset Card
Click on Forced Reset
15. When the card reboots you should be able to call across the network.
Additional Requirements/Trouble Shooting
NEAX 2000IPS
9. CM 08>373>0
10. CM 08>376>0
11. CM
35134>30>XX
Precedence(XX)
12. CM
A744>0>XX
Precedence(XX).
13. CM
35161>0>XX
(XX)
14. CM
A750>0>XX
point(XX)
15. CM 8A5030>174>0
16. CM A761>0>4~7
17. CM 35145>XX>0
IPS.
Trouble Shooting
a. Make sure voice and signaling ports are open through the IP Network. See IP Port
Numbers Used For CCIS below. Test systems back to back to rule out network issues.
b. If there is also regular T1 CCIS in the system the CIC's in CM 3035 must be unique to all
trunks or link re-connect will not work. E.g. In this cheat sheet example CIC's 1~8 were
used. If a T1 CCIS span were installed its CM 30-35 cannot contain CIC's 1~8.
c. Point to Muti-Point CCIS over IP should use CCH 0. If there is also Peer to Peer CCIS to
other NEAX systems the CCIS IP trunking will be CCH1 with the Peer to Peer as CCH 0.
T1 CCIS would utilize CCH's 2 and higher.
d. Make sure the CCH trunk D254 assigned in A700>X is not assigned any setting in CM 30.
e. Sometimes after all programming is complete on this application and confirmed correct
the MP requires one last reset before calls can be completed.
(The 2000 is set for G.729)
If centralized VM
If centralized VM
For QOS (Voice packets) when IP network uses TOS field
For QOS (Signaling packets) when IP network uses TOS field
For QOS (Voice packets) when IP network uses Diffserv DS code point
For QOS (Signaling packets) when IP network uses Diffserv DS code
To allow link reconnect to 2400 ONLY.
To change or cancel the Voice compression rate. 0 = CCH route
Caller ID from key system to pass out IPS ISDN B channel route (XX) in
NEAX 2000 Cheat Sheet
(If this is checked it does not
(These changes will not take place
(The comment field is just for
Advertisement
