Advertisement
Page 4 of 6
System Programming Elite IPK
1. MB 7-1 assign the card as a DTI (8)
2. MB 1-11-03 assign CCIS over IP as YES
3. MB 1-11-05 turn ON the first 8 line keys
4. MB 1-11-07 set TRK 1 and 2 to E&M
5. MB 3-91 assign all 8 channel's as TIE
6. MB 3-03 assign all 8 channel's to trunk group 10. (This is only an example, you can use any trunk
group except trunk group 01)
7. MB 3-04 assign all trunks as YES
8. 1-8-08 turn ON the following:
Pg. 3 line key 5
Pg. 4 line key 3
Pg. 5 line keys 4&7
9. MB 4-18 assign station names
10. MB 4-12 assign CAP keys on all phones
11. MB 1-8-26 assign the Voice Mail Pilot number if you are using Centralized Voice Mail.
12. MB 1-15-00 set to REMOTE (This is new with 2.5 software and above, older software does not
require this MB to be turned on).
Closed Numbering Plan
1. MB 1-1-46 assign 2 = 401
2. MB 1-1-49 assign 01 = RT 110
3. MB 1-1-50 assign 01 = 2
IAD Setup
1. Once the LED's CH8 and CH7 are lit solid and the Status LED is flashing red, connect your PC to
the IAD (8)-U ( ) ETU Ethernet connector (The bottom RJ-45 connector).
2. The IAD (8)-U ( ) ETU Default IP Address is: 192.168.1.100.
Set your PC so that it is statically assigned an IP address of 192.168.1.xxx with a subnet mask of
255.255.255.0 to ensure it is in the same network as the IAD(8)-U( ) ETU.
3. Point the Microsoft Internet Explorer browser to the internet navigational bar and type the
following IP address: 192.168.1.100
4. On the IAD (8)-U ( ) ETU Login screen enter the following information. Default Login ID= admin
(Lower case). Default Password= password (Lower case).
5. On the Welcome screen make sure that the card is service pack 4. If the card is at service pack 4
then click on Browse and locate the IPCCH_NEAX package and Upload the file. At time of
writing the latest firmware package is 4.04 (file name IPCCH_NEAX_Ver4.04T1.pkg)
6. Once the screen pops shows that the Package has been successfully delivered wait about 30
seconds and remove the IAD(8)-U( ) ETU.
7. Set dip switch 2 to have only 5, 6, and 7 ON. The rest of the switches should be OFF.
an 8 port configuration).
8. Insert the IAD (8)-U ( ) ETU back into the system and wait until all 8 LED's go out and the only
light left flashing is the Live Led.
9. Log back into the card with the default Login and Password.
10. You will now be on the Card Configuration screen.
Change the IP Address to 192.168.2.150
Change the Subnet Mask to 255.255.255.0
Change the Default Gateway to 192.168.2.1
Click the Submit Tab at the bottom of the page.
the card has been rebooted)
(Station trunk to trunk transfer)
(Caller ID)
(Call forward Off Prem. & Caller ID Name and Number)
(This is because the trunks are in trunk group 10)
NEAX 2000 Cheat Sheet
(These changes will not take place until
(This is for
Advertisement
