Advertisement
Page 3 of 6
Feature Programming NEAX 2000 IPS
Programming for the IPS with IPTB board in LT06 and VCTI boards in LT07 and LT08. LT slots 09,
10, and 11 are empty. The IPTB Sense wheel is on a 08. IP addressing, trunk, route, and station
numbers are for example only.
1. CM 050>08>38
2. CM 0607>0>08
3. CM 14>00056>D100
4. CM 14>00057>D101
5. CM 14>00058>D102
6. CM 14>00059>D103
7. CM
14>00036>D104
8. CM
14>00037>D105
9. CM
14>00038>D106
10. CM
14>00039>D107
11. CM 14>03063>D254
12. CM 3000>100~107>30
13. CM 3500>30>04
14. CM 3504>30>2
15. CM 3509>30>03
16. CM 3520>30>00
17. CM 3590>30>0
18. CM 3591>30>0
19. CM 3035>100~107>001~008
20. CM 3044>100~107>01~08
connected to the IPTB board. Therefore it is always recommended to install the VCTI boards to
the right of the IPTB. This helps keep the programming in a more orderly fashion.
21. CM A700>0>254
22. CM A701>0>00001
23. CM A702>0>NONE
24. CM A726>0>0
25. CM A728>0>0
26. CM A740>0>192168001100
27. CM A741>0>255255255000
28. CM A742>0>192168001001
29. CM A746>0>0
30. CM 200>3>A129
31. CM 8AA000>3>4007
32. CM 8A4007>3>0030
33. CM 8A0030>1>03020
34. CM 8A5030>167>030
35. CM 8A5030>168>00002
36. CM 5B01>03000>192168002150
37. CM A8>00002>0
38. CM 08>253>0
39. CM 08>379>0
Additional assignments that may be required....
1. CM 08>373>0
2. CM 08>376>0
3. CM 35134>30>XX
4. CM A744>0>XX
5. CM 35161>0>XX
6. CM A750>0>XX
7. CM 8A5030>174>0
8. CM A761>0>4~7
The example shows the VCTI's in LT07 and LT08.
This is to help identify how utilizing the 4 port only
slot
(LT08)
can enable another 4 port card to be used
in LT 04, as shown in this case. Also as shown
another 4 port card could also be installed in LT11
using the LENs 060~063 (top half of LT 07).
This CCH trunk must be assigned to an unused LEN.
If wired CCIS is also in the system the IP should use CCH 0.
Setting 01 must be set to the first trunk on the first VCT
To send station name display to the IPK.
To send received caller ID to the IPK.
This is the only place you enter the dest. IP address.
If centralized VM
If centralized VM
For QOS when IP network uses TOS field Precedence
For QOS when IP network uses TOS field Precedence
For QOS when IP network uses Diffserv DS code point
For QOS when IP network uses Diffserv DS code point
To allow link reconnect to 2400 ONLY.
To change or cancel the Voice compression rate.
NEAX 2000 Cheat Sheet
Deleted: <sp><sp>
Advertisement
