Identification; Safety Notice; Notes For Dielectric Stiffness Tests; Reference Standards - ABB TS3 Instruction Manual

1. Identification

TS3 is a testing device that realizes functionality verification on Low Voltage ABB SACE air circuit breakers electronic trip
units, with one-phase secondary current injection.

2. Safety notice

Read this manual carefully and completely.
WARNING: this symbol gives information about operations, actions or circumstances that can cause injuries to
!
the personnel, damage to the unit or economic losses.
The use of this device should be reserved for qualified and expert personnel only.
If in doubt, about its safe usage, the unit must be put out of service to prevent any accidental use.
You must assume that safe usage is impossible if:
1. the unit shows visible signs of damage.
2. the unit does not function (for example the display does not switch on).
3. the unit has been damaged in transit.
WARNING: before proceed with any testing and control operation with the TS3 testing device, carefully read
instructions and procedures in the following chapters.
!
ABB S.p.A. SACE Division disclaim all responsibility for damages to things or people, due to incorrect use of
TS3 test unit or/and for negligence on the present instructions
WARNING: Prior to operate and / or carry out any replace ments on the CB, this must be open, with
!
discharged spring and disconnected
Further, all connected power supplies must be disabled.

2.1 Notes for dielectric stiffness tests

Dielectric stiffness tests on TS3, inputs and outputs, are not permitted.
!
In case dielectric test of any devices or circuit breakers connected to TS3, it is necessary to remove any
connections between the TS3 and the device under test.

2.2 Reference standards

TS3 test unit is CE marked and is conform to the main international reference standards in terms of electromagnetic
compatibility (EMC) and safety.
Immunity for industrial environments : IEC 61000-6-2 Standard.
Emission for industrial environments : IEC 61000-6-4 Standard.
Safety requirement for measurements, control and laboratory use electrical equipment: IEC 61010 Standard.
888.902.6111
TS3 1SDH000670R0002
www.intellirentco.com
|
L3852 4/44