Festool CXS Original Operating Manual page 12

CXS
GB
7 Settings
WARNING
Risk of injury

Always switch off the machine before adjusting
settings!
7.1 Changing direction of rotation [1-5]
• Switch to the left = clockwise rotation
• Switch to the right = counterclockwise rotation
7.2 Changing gear [1-4]
• Gear switch forwards (digit 1 visible) = 1st gear
• Gear switch to rear (digit 2 visible) = 2nd gear
7.3 Adjusting torque [1-1]
The arrow [1-3] aligns with the adjusted state.
Drilling
Drilling symbol [1-2] on adjustment ring aligns
with the arrow = maximum torque..
Fastening
Torque corresponding to setting:
Position 1 = low torque
Position 12 = high torque
8 Tool holder, attachments
WARNING
Risk of injury, electric shock

Always disconnect the battery pack before any
type of work on the machine!
The order numbers of the accessories and tools can
be found in the Festool catalogue or on the Internet
under "www.festool.com".
8.1 CENTROTEC tool chuck [4]
Quick change of tools with CENTROTEC shaft
Only clamp CENTROTEC tools in CENTRO-
TEC tool chucks.
Wear gloves when replacing!
8.2 Chuck BF-FX8 [5]
For clamping drill bits and bits with max. shaft di-
ameter of 8 mm.
Clamp tool centricly in the chuck.
8.3 Elbow adapter XS-AS [6]
(accessories) Drilling and screwdriving at right an-
gle to machine.
12
 You can engage the elbow adapter in 16 different
angle settings.
8.4 Tool holder in the drill spindle [7]
Bits can be inserted directly into the hexagon sock-
et holder of the drill spindle.
9 Working with the machine
9.1 On/Off switch [1-6]
Press = ON, release = OFF
 The speed of the machine depends on how far
the on/off switch is pressed in.
The LED bulb [1-10] lights up when the ON/OFF
switch is pressed [1-6].
9.2 Bit depot [1-9]
Magnetic, for storing bits and bit holders.
9.3 Warning signals [8]
Machine shuts down, light flashes twice:
Battery pack is empty.

Change the battery pack.
Machine shuts down, light does not flash:
Machine is overheated or has been overloaded.

Reduce the machine load.

Allow the machine to cool down.
10 Service and maintenance
Customer service and repair only
through manufacturer or service
workshops: Please find the nearest
address at:
www.festool.com/Service
EKAT
Use only original Festool spare parts!
4
Order No. at:
5
www.festool.com/Service
3
2
1
Note the following information:
– Keep the ventilation slits on the machine free and
clean to ensure adequate cooling.
– Keep the contacts on the machine, charger and
battery pack clean.
Information on battery packs
– Store in a cool, dry place at a temperature be-
tween 5 °C and 25 °C.
– Protect battery packs from moisture, water and
heat.
– Do not leave flat battery packs in a charger dis-
connected from the mains power supply for lon-
ger than one month. Danger of deep discharge!
– If you intend to store li-ion battery packs for lon-