Secure Cover - Chamberlain RFDIC User Manual

Mounting with Tape
Step 1
Clean back of doorbell and mounting surface using
the alcohol wipe.
Step 2
Peel off white paper from mounting tape. Firmly press
mounting tape on back of doorbell.
Step 3
Peel paper from mounting tape. Firmly press doorbell
onto mounting surface.

Secure Cover

Secure cover with the
two large black screws.
Program Additional Intercoms
The intercom can be programmed to at least one
other intercom to become a network or it can be
programmed into an existing network.
Create New Network
Press the Learn button on the new intercom until a
beep is heard. Within 10 seconds put the second
intercom into Learn Mode (refer to table below).
INTERCOM
OR
Each intercom will emit a tone when programmed into
network. Repeat for any additional intercoms.
Add to an Existing Network
Press the Learn button on the new intercom until a
beep is heard. Within 10 seconds put any networked
intercom into Learn Mode (refer to table below).
INTERCOM
OR
Each intercom will emit a tone when programmed into
network. Repeat for any additional intercoms.
NOTE: Do not program new intercoms to each other
before adding them to the network or they will form a
separate network and the memory will need to be
cleared.
3
LEARN MODE
Press the Learn button until
a beep is heard.
Press and hold both buttons
for 5 seconds.
LEARN MODE
Press the Learn button until
a beep is heard.
Press and hold both buttons
for 5 seconds.