Developer Features; Encoder Command Concept - EEG iCap HD492 Manual

Developer Features

Encoder Command Concept

Encoder Commands allow you to communicate with and control the operation of your encoder either manually or
through your custom written software that contains any combination of the commands detailed in this section. All
commands begin with a leading control code of <CTRL+A> or the ASCII hex code 01 for developers writing
software. All commands must end with a carriage return (the <ENTER> key on a keyboard or 0D in ASCII hex). For
manual entry of commands, the three following methods may be used. A Full Command Reference may be found
at the end of this section.
Telnet: Commands may be entered through a telnet connection to your encoder only after you've enabled a telnet
connection through your encoders web interface (select Telnet from the side menu)
Web Terminal: The Command Terminal is found on the web interface of your encoder (select Terminal from the
side menu). This emulates the serial port interface to your encoder and allows you to enter commands directly
from your encoders web interface (see figure 19).
RS-232: Commands may be entered through an RS-232 connection to your encoder. Default settings on the
encoder allow entry through RS-232 right out of the box.
Figure 9: Command Terminal on the Encoder Web Interface
Copyright © 2021 EEG Enterprises, Inc. 38
All Rights Reserved.