Still Mode; No Noise Background; Brightness; Dvd Output - Sharp DV-RW270S Operation Manual

Setting the screen

STILL MODE

You can select the type of DVD still picture image
displayed on the TV screen.
Select "STILL MODE" and select the image to be dis-
played from the list below.
AUTOMATIC
The field still or frame still is automatically selected.
(For normal use.)
STILL BY FRAME
The frame still is set.
Note for the field still and frame still:
(with 480i interlaced scanning mode)
• Field* still (240 lines)
Since only one field (half of the video information) is
displayed on the TV screen, the picture appears rough
but does not shake.
• Frame* still (480 lines)
Two fields are alternatively displayed on the TV
screen. The picture may shake but resolution quality
of the picture is superior to the field still pictures.
Field*: A field refers to the video information in one-half
of a frame. 1 frame (screen) consists of 2 fields.
Frame*: A frame refers to the total area occupied by
each picture on the TV screen.

NO NOISE BACKGROUND

When you select a channel where the broadcast has
finished or no broadcast is set, the TV screen will auto-
matically appear blue.
The function above works when you select "NO NOISE
BACKGROUND" and select "ON" from the list. If you
don't want to use this blue background function, select
"OFF".
The default setting is "ON".

BRIGHTNESS

You can control the brightness level of the image.
Select "BRIGHTNESS" and select the level from the
below.
MAX: The image becomes brighter.
STD: The image is of standard brightness.
MIN: The image becomes darker.
24
GB

DVD OUTPUT

You can select the output signal of DVD playback pic-
ture to the TV screen. Select DVD OUTPUT and select
the output type from the list below.
RGB: RGB signal and COMPOSITE signal
via SCART socket
COMPONENT: COMPONENT VIDEO signal via
SCART socket and COMPONENT
OUT jacks
S-VIDEO: S-VIDEO signal via SCART socket
NOTES:
• An RGB output is available when being connected
to TV using SCART connector.
When you press STOP on the front panel for 5 sec-
onds, DVD OUTPUT setting will be restored to
"RGB".
• When a SCART socket is used to connect the unit
with a TV, it is advisable to set the DVD OUTPUT to
"RGB" in order to see the colours of the screen
correctly. If you set the DVD OUTPUT to
"COMPONENT", the screen will appear green on
some TV models. This is not a fault of the unit.

AV2

If there have a decoder connected to the AV2 Scart
socket, select "AV2" and select "DECODER" from the
list.

AV3 INPUT

You must select the input mode of AV3 (front AV-input).
(see the upper connection on page 80)
Only the S-Video signal will be input.
S-VIDEO:
(Composite video signal will be cut.)
VIDEO: Only the composite video signal will
be input. (S-Video input signal will be
cut.)