Bona DCS70 Manual And Safety Instruction page 6

Bona DCS70 / Portable DCS®
Collection
Particles and dust falls down into a transparent dust container under the cyclone separator.
Inside the dust container is a Longopac bag hose system which should be replaced when full.
The system consists of a 65 ft folded plastic hose, which gives about 20 dust free bag changes.
1. Seal the bag with two
cable ties.
Replacing the Longopac magazine
Start of with locking the wheel brakes.
1. Cut the bag open
5. Place a new
Longopac magazine
and check the opening
according to the
picture
9. Turn the magazine
over and pull out a
new bag
NOTE: Always clean the tank from all the particles before you start the machine again!
Otherwise, the HEPA filter will be damaged or clogged.
2. Cut between the
cable ties.
2. Loosen the straps
6. Cut off the sealers
10. Put the magazine in
place
(does not cover warranty)
3. Pull out a new bag from the
Longopac.
3. Pull out the
magazine
7. Fold the inner
Longopac over the
edge
11. Attach the
straps
6
4. Remove the
gasket and discard
the Longopac rest
8. Mount the gasket
12. Seal the bag with
a sealer and cut off
any rest