Installing The Light Bulb(S); Electrical Requirements - Chamberlain 248730DM Assembly & Installation Manual

INSTALLING THE LIGHT BULB(S)

Flex Sides of Light Lens to
1
Remove Lens from Tabs
WARNING

ELECTRICAL REQUIREMENTS

CAUTION
1 Plug Motor Unit into Power Outlet
RIGHT
NOTE: Plug motor unit into grounded power outlet. If a grounded outlet is not available, contact a qualified
electrician to install a proper outlet.
If permanent wiring is required by your local code, follow procedure below. Disconnect power to the
circuit before removing cover to establish permanent wiring connections.
1 Remove Motor Unit
Screws and Cover
Rotate Light Lens Down
2
WRONG
2 Remove Power
Cord
Black
Ground Wire
Wire
White Wire
Black Wire
To prevent possible OVERHEATING of the endpanel or light
socket:
• DO NOT use short neck or specialty light bulbs.
• DO NOT use halogen bulbs. Use ONLY incandescent.
To prevent damage to the opener:
• DO NOT use bulbs larger than 100W.
• ONLY use A19 size bulbs.
3
To prevent possible SERIOUS INJURY or DEATH from
electrocution or fire:
• Be sure power is NOT connected to the opener, and
disconnect power to circuit BEFORE removing cover to
establish permanent wiring connection.
• Garage door installation and wiring MUST be in compliance
with ALL local electrical and building codes.
• NEVER use an extension cord, 2-wire adapter, or change
plug in ANY way to make it fit outlet. Be sure the opener is
grounded.
OR
3 Run Wire from
Outlet to Motor Unit
Ground Tab
Green
Ground Screw
Ground Wire
White Wire
16
WARNING
CAUTION CAUTION
Install Standard Light Bulb(s)
(100W max) into Socket(s)
100 Watt (Max)
Standard Light Bulb
WARNING WARNING
WARNING
4 Replace Motor Unit
Cover and Screws
Black
Wire
Black