INSTALLING THE LIGHT BULB(S)
1
Flex Sides of Light Lens to
Remove Lens from Tabs
WARNING
ELECTRICAL REQUIREMENTS
CAUTION
1
Plug Motor Unit into Power Outlet
RIGHT
NOTE: Plug motor unit into grounded power outlet. If a grounded outlet is not available, contact a qualified
electrician to install a proper outlet.
If permanent wiring is required by your local code, follow procedure below. Disconnect power to the
circuit before removing cover to establish permanent wiring connections.
1
Remove Motor Unit
Screws and Cover
2
Rotate Light Lens Down
WRONG
2
Remove Power
Cord
Black
Ground Wire
Wire
White Wire
Black Wire
To prevent possible OVERHEATING of the endpanel or
light socket:
• DO NOT use short neck or specialty light bulbs.
• DO NOT use halogen bulbs. Use ONLY incandescent.
To prevent damage to the opener:
• DO NOT use bulbs larger than 100W.
• ONLY use A19 size bulbs.
3
To prevent possible SERIOUS INJURY or DEATH from
electrocution or fire:
• Be sure power is NOT connected to the opener, and
disconnect power to circuit BEFORE removing cover to
establish permanent wiring connection.
• Garage door installation and wiring MUST be in compliance
with ALL local electrical and building codes.
• NEVER use an extension cord, 2-wire adapter, or change plug
in ANY way to make it fit outlet. Be sure the opener is
grounded.
OR
3
Run Wire from
Outlet to Motor Unit
ECTION
round Tab
d Wire
White Wire
16
WARNING
CAUTION
CAUTION
Install Standard Light Bulb(s)
(100W max) into Socket(s)
100 Watt (Max)
Standard Light Bulb
WARNING
WARNING
WARNING
4
Replace Motor Unit
Cover and Screws
Black
Wire