Loading Door Lock; Changing The Selections After Programme Has Started - Beko WUE 8622 XW User Manual

4.3.14 Loading door lock

There is a locking system on the loading door of the machine that prevents opening of the
loading door in cases when the water level is unsuitable.
Loading door light will start flashing when the machine is switched to Pause mode. The
machine checks the level of the water inside. If the level is suitable, the loading door light will
turn off and the loading door can be opened within 1-2 minutes.
If the level is unsuitable, the loading door light will remain on and the loading door cannot be opened.
If you are obliged to open the loading door while the Loading Door light is on, you must cancel the
current programme. See "Cancelling the programme"
Opening the loading door in case of power failure:
C
INFORMATION
• In case of a power failure, you can use the loading door emergency handle under the pump filter lid to
manually open the loading door.
A
WARNING!
• Before opening the loading door, make sure that there is no water in the machine to avoid flooding. Water
may be hot and could cause scalding.

4.3.15 Changing the selections after programme has started

Switching the machine to pause mode
Press the Start/Pause to switch the machine to pause mode while a programme is running. The
light of the current programme will flash on the Programme Follow-up indicator, indicating that the
machine has switched to pause mode.
Also, when the loading door is ready to be opened, the Loading Door light will turn off in addition to
the programme step light.
Washing Machine / User's Manual
• Turn off and unplug the appliance.
• Open the pump filter lid.
• Remove the loading door emergency handle behind the
filter cover with a tool.
• Open the loading door by pulling the loading door
emergency handle downwards.
• Try to pull the handle downwards again if the loading
door is not opened.
• Bring the loading door emergency handle to its original
position after opening the loading door.
23 / EN