Advertisement
Installation
Flow Meter Electronics Kit
24J318
1. Perform HFR Shutdown procedure. See HFR oper-
ation manual for detailed instructions.
2. Use two 111800 hex head screws (supplied) to
mount electronics assembly 24J318 to the bottom of
the electrical enclosure. If there are transformers
installed, remove two of the hex head screws from
the transformers and use those two holes to mount
the electronics assembly and discard the supplied
hex head screws.
3A1657A
3. Connect CAN cable to CAN connection labeled "1"
on the fluid control module.
4. Connect opposite end of the CAN cable (111) to any
free CAN port on any other fluid control module or
temperature control module in the system. If none
are available, use CAN cables (111 and 113) to con-
nect to CAN splitter inside the power distribution
box. See references on page 14.
ti17009a
ti17010a
Installation
ti17011a
3
Advertisement
