Section Ii: Barrier Locations; Product Description - Bestway 51033 Owner's Manual

should be equipped with manual means, such as touchpads or
switches, to temporarily deactivate the alarm for a single opening of the
door from either direction. Such deactivation should last for nomore
than 15 seconds. The deactivation touchpads or switches should be
located at least 54 inches above the threshold of the door.
(b) The pool should be equipped with a power safety cover which
complies with ASTM F1346-91 listed below.
(c) Other means of protection, such as self-closing doors with self-latching
devices, are acceptable so long as the degree of protection afforded is
not less than the protection afforded by (a) or (b) described above.
10. Where an aboveground pool structure is used as a barrier or where the
barrier is mounted on top of the pool structure, and the means of access is
a ladder or steps, then (a) the ladder to the pool or steps should be
capable of being secured, locked or removed to prevent access, or (b) the
ladder or steps should be surrounded by a barrier which meets Section I,
Paragraphs 1 through 9. When the ladder or steps are secured, locked, or
removed,any opening created should not allow the passage of a 4-inch
diameter sphere.

Section II: Barrier Locations

Barriers should be located so as to prohibit permanent structures, equipment
or similar objects from being used to climb the barriers.

Product Description

Item
51033; 51061
51004; 51012; 51024;
51025; 51026; 51027;
51103; 51104; 51115; 51118
55021; 55029; 55030; 51128
93403; 93205; 51130;
51008; 51009; 55022
51085
93501
51120; 51124
Refer to the item name or number stated on the packaging. Packaging must
be read carefully and kept for future reference.
Preparation
Installation of small swimming pool usually takes only 10 minutes with 1
people.
Recommendations regarding placement of the pool:
• It is essential the pool is set up on solid, level ground. If the pool is set up on
uneven ground it can cause collapse of the pool and flooding, causing
serious personal injury and/or damage to personal property. Setting up on
uneven ground will void the warranty and service claims.
• Do not set up on driveways, decks, platforms, gravel or asphalt. Ground
should be firm enough to withstand the pressure of the water; mud, sand,
soft / loose soil or tar are not suitable.
• The ground must be cleared of all objects and debris including stones and
twigs.
• Check with your local city council for by-laws relating to fencing, barriers,
lighting and safety requirements and ensure you comply with all laws.
Assembly
1. Take the pool and accessories out of the carton with care and spread out
the pool on to the selected site.
2. To inflate the pool, start from the bottom chamber and work your way to the
top chamber and close the safety valves after inflation. Do not over-inflated
your pool. (For inflatable pool only)
3. Slowly fill with water to pool just below the fill line on the pool's interior. Do
not exceed the fill line on the pool's interior. DO NOT OVERFILL as this
could cause the pool to collapse.
ATTENTION: Do not leave pool unattended while filling with water.
Part
• Pool
• Repair patch
• Pool
• Repair patch
• 50 balls
• Pool
• Repair patch
• 25 balls
• Pool
• Repair patch
• Swim ring
• Beach ball
Proper Water Level
Inflatable Pool
NOTE: All drawings for illustration purpose only. May not reflect actual
product. Not to scale.
Empty the pool
1. Check local regulations for specific directions regarding disposal of
swimming pool water.
2. For the inflatable pool, deflate all the air chambers, at the same time push
down the wall of the pool to release the water.For the Fill 'N Fun Pool, push
down the wall of the pool to release the water.Make sure release all the
water in 20 minutes.
NOTE: Drain by adult only!
Pool Maintenance
Warning: If you do not adhere to the maintenance guidelines covered herein,
your health might be at risk, especially that of your children.
• Change the water of pools frequently (particularly in hot weather) or when
noticeably contaminated, unclean water is harmful to the user's health.
• Please contact your local retailer to obtain chemicals to treat the water in
your pool. Be sure to follow the chemical manufacturer's instructions.
• Proper maintenance can maximize the life of your pool.
• See packaging for water capacity.
Cleaning and Storage
1. After use, use a damp cloth to gently clean all surfaces.
Note: Never use solvents or other chemicals that may damage the product.
2. Air dry the pool, once pool is completely dry, fold pool carefully and put
back to its original packing. If pool is not completely dry, mould may result
and will damage the pool.
3. Store in a cool, dry place and out of children's reach.
4. Check the product for damage at the beginning of each season and at
regular intervals when in use.
Repair
If your pool is damaged, use the repair patch.
1. Complete deflate the product damaged area.
2. Clean and dry the damaged area.
3. Apply the repair patch and smooth out any air bubbles.
2
Proper Water Level
Fill 'N Fun Pool
S-S-004517