Section Ii: Barrier Locations; Product Description - Bestway 52162 Owner's Manual

dBA at 10 feet and the sound of the alarm should be distinctive
from other household sounds, such as smoke alarms, telephones,
and door bells. The alarm should automatically reset under all
conditions. The alarm should be equipped with manual means,
such as touchpads or switches, to temporarily deactivate the alarm
for a single opening of the door from either direction. Such
deactivation should last for nomore than 15 seconds. The
deactivation touchpads or switches should be located at least 54
inches above the threshold of the door.
(b) The pool should be equipped with a power safety cover which
complies with ASTM F1346-91 listed below.
(c) Other means of protection, such as self-closing doors with
self-latching devices, are acceptable so long as the degree of
protection afforded is not less than the protection afforded by (a) or
(b) described above.
10. Where an aboveground pool structure is used as a barrier or where
the barrier is mounted on top of the pool structure, and the means of
access is a ladder or steps, then (a) the ladder to the pool or steps
should be capable of being secured, locked or removed to prevent
access, or (b) the ladder or steps should be surrounded by a barrier
which meets Section I, Paragraphs 1 through 9. When the ladder or
steps are secured, locked, or removed,any opening created should
not allow the passage of a 4-inch diameter sphere.

Section II: Barrier Locations

Barriers should be located so as to prohibit permanent structures,
equipment or similar objects from being used to climb the barriers.

Product Description

Item
52162; 52179; 52219; 52218; 52211
52188;52189;52192;52196
52212
Refer to the item name or number stated on the packaging. Packaging must
be read carefully and kept for future reference.
Preparation
Installation of small swimming pool usually takes only 10 minutes with 1
people.
Recommendations regarding placement of the pool:
• It is essential the pool is set up on solid, level ground. If the pool is set
up on uneven ground it can cause collapse of the pool and flooding,
causing serious personal injury and/or damage to personal property.
Setting up on uneven ground will void the warranty and service claims.
• Do not set up on driveways, decks, platforms, gravel or asphalt. Ground
should be firm enough to withstand the pressure of the water; mud,
sand, soft / loose soil or tar are not suitable.
• The ground must be cleared of all objects and debris including stones
and twigs.
• Check with your local city council for by-laws relating to fencing, barriers,
lighting and safety requirements and ensure you comply with all laws.
Assembly
Warning: Adult assembly required.
1. Take the pool and accessories out of the carton with care and spread
out the pool on to the selected site.
2. Open the safety valves and inflate the parts one by one. Be sure to
close the valves after inflation. Air pump is not included.
NOTE: Do not over inflate. Do not use either an air compressor or
compressed air.
3. Slowly fill with water to pool just below the fill line on the pool's interior. Do
not exceed the fill line on the pool's interior. DO NOT OVERFILL as this
could cause the pool to collapse.
ATTENTION: Do not leave pool unattended while filling with water.
Part
• Pool
• Repair patch
• Pool • Repair patch
• Five crayons
Proper Water Level
NOTE: All drawings for illustration purpose only. May not reflect actual
product. Not to scale.
Empty the pool
1. Check local regulations for specific directions regarding disposal of
swimming pool water.
2. Deflate all the air chambers, at the same time push down the wall of
the pool to release the water. Make sure release all the water in 20
minutes.
NOTE: Drain by adult only!
Pool Maintenance
Warning: If you do not adhere to the maintenance guidelines covered
herein, your health might be at risk, especially that of your children.
• Change the water of pools frequently (particularly in hot weather) or when
noticeably contaminated, unclean water is harmful to the user's health.
• Please contact your local retailer to obtain chemicals to treat the water in
your pool. Be sure to follow the chemical manufacturer's instructions.
• Proper maintenance can maximize the life of your pool.
• See packaging for water capacity.
Cleaning and Storage
1. After use, use a damp cloth to gently clean all surfaces.
Note: Never use solvents or other chemicals that may damage the
product.
2. Air dry the pool, once pool is completely dry, fold pool carefully and
put back to its original packing. If pool is not completely dry, mould
may result and will damage the pool.
3. Store in a cool, dry place and out of children's reach.
4. Check the product for damage at the beginning of each season and at
regular intervals when in use.
Repair
If your pool is damaged, use the repair patch.
1. Complete deflate the product damaged area.
2. Clean and dry the damaged area.
3. Apply the repair patch and smooth out any air bubbles.
2
S-S-004522